AENO AEK0008S Electric Smart Kettle User Guide
- June 15, 2024
- AENO
Table of Contents
Quick Start Guide
Smart Kettle
EK7S/EK8S
EK7S-UK/
EK8S-UK
(Models: AEKO007S, AEKOOO7S-UK,
AEKOO08S, AEKOO08S-Uk)
12.10.2023 | v 1.1.3
How to connect
Electric smart kettle AENO is designed for heating and boiling water at home
and in the office.
Model: AEK0007S/AEK0008S (Plug Type E/F), AEK0007S-UK/AEK0008S-UK (Plug Type
G).
Technical Specifications
Supply voltage: 220–240 V AC; Frequency: 50–60 Hz. Power: 1850.0–2200.0 W.
Dimensions (L×W×H): 212×162.3×262 mm. Capacity: 1.7 L. Water heating modes
with manual control: +40 °C, +55 °С, +80 °C, +90 °C, +100 °С, the range of
temperature adjustment when controlling through the application AENO: 40–100
°C. Function of maintaining the set temperature: up to 24 h. Emission
power: +20 dBm/100 mW.
Scope of Supply (fig. A)
Smart kettle AENO, stand (10), quick start guide.
Limitations and Warnings
The kettle is intended for domestic use only. Before using for the first time,
make sure that the network parameters are in accordance with the
specifications in the technical data sheet. Do not use a damaged device or
device with a damaged power cord and/or plug. Do not allow the power cord to
come in contact with sharp edges or hot surfaces. Do not immerse the power
cord, power plug, kettle or stand in water or other liquids. Do not use the
device outdoors. Place the kettle on a flat, stable surface. To prevent damage
to the plastic components, install the device away from external sources of
heat and do not place the device near or on top of other electrical
appliances. Do not turn on an empty kettle to avoid damage. Use purified If
you have any issues or difficulties using your AENO device, please contact
support by email at support@aeno.com or via the
online chat at aeno.com/service-and-warranty. Our specialists will help you solve the problem, and you will not
have to spend time and effort visiting the shop.
water to reduce limescale buildup. Use the kettle for heating water only. Do
not allow children to use the kettle unsupervised. Do not open the kettle
while it is boiling or during the first few minutes after boiling. Be careful
when pouring boiling water, do not tilt the kettle with boiling water too
sharply.
Make sure the lid is closed before you lift the kettle. Do not pour water
below the MIN mark and above the MAX mark on the inside of the housing. Use
the device only with the supplied stand. Unplug the unit when not in use and
before cleaning.
Preparing the device for operation
Before using the kettle for the first time, fill the kettle to the MAX mark.
Boil and drain the water. Wipe the outer and inner surfaces of the kettle with
a damp cloth. Allow it to dry. Make sure there is no moisture left on the
stand and the kettle.
Operating the device
Controlling the device via the control panel
Function | Actions |
---|---|
Boiling | • Fill the kettle with water by removing the kettle from the stand, |
opening the lid by pressing the button on the top of the handle, and draw the
desired amount of water.
• Close the lid tightly and place the kettle on the stand.
• Plug the power cord into a power outlet.
• Press the power button (6) on the device panel. The indicator (7) will light
up. After the water boils, the device will beep three times and go into
standby mode
Maintaining the set water
temperature after boiling for
24 hours| • Fill the kettle with water (see instructions in section
“Boiling”).
• Press the power button (6), the indicator (7) will light up and the boiling
process will start.
• During the boiling process, use the “+/-” button (9) toset the desired
temperature (+40 °C, +55 °C, +80 °C or +90 °C). The indicator (8) will light
up.
• After the water boils, the indicator (7) will go off, the indicator (8) will
start blinking. When the kettle reaches the set temperature it will beep three
times and go into temperature maintenance mode
Heating and maintaining the
set temperature without boiling
for 24 hours| • Fill the kettle with water (see instructions in section
“Boiling”).
• Use the “+/-” button (9) to set the desired temperature (+40 °C, +55 °C, +80
°C or +90 °C). The indicator (8) will light up.
• When the kettle reaches the selected temperature, it will beep three times
and go into temperature maintenance mode
WARNING! If you unintentionally turn on the kettle without water, it will turn off automatically. Wait for the kettle to cool down before filling and turning it on again, otherwise the kettle will be blocked by the safety mechanism. Note: You can interrupt the heating or holding temperature process by pressing the power button (6) again or by removing the kettle from the stand.
Control the device via the AENO mobile app
WARNING! Make sure your phone is connected to a 2.4 GHz Wi-Fi network.
-
Connect the device to the power supply and turn it on.
-
Log in to your account in the AENO app or register a new one by downloading the mobile app from Google Play or the App Store.
-
On the main application screen, tap “+” or “Add device”. In the window that opens, select the category “Kettle”.
Note: When system requests appear to enable any functions on your smartphone, follow the recommendations indicated in them. -
Enter your Wi-Fi network name and password if they are not filled in automatically and click “Next”.
-
On the control panel of the kettle, press and hold the power button until the 2 indicators (7) and (8) start flashing and the device beeps three times.
-
In the application on the “Connection instructions” screen check the “The indicator is blinking” box. Click “Next”.
-
Wait until the message “Device added successfully” appears.
Note: The device can also be controlled via voice assistants. Detailed information is available in the Installation and Operation Manual at aeno.com/documents. If the connection fails, make sure the device is connected to a power source and turned on, check the Wi-Fi router settings at aeno.com /router-help, remove the kettle from the stand, put it back on the stand, and then repeat the connection process.
Descaling
Frequency: Once a month (hard and very hard water) or once every 2–3 months
(water of medium hardness or soft) when using the kettle 3–5 times a day.
Limescale remedies and cleaning methods
Table vinegar | Citric acid | Special descale |
---|
Pour 0.5 l of vinegar (6 % or 9 %) into the kettle, leave for 1 h without
boiling. Pour out the contents, wash the
kettle and boil and drain the water 5–6 times| Boil 0.5 l of water. Add 25 g
of citric acid and leave for 15 min. Pour out the contents, wash the kettle
and boil and drain the water 5–6 times| Follow the manufacturer’s
instructions on the package
Troubleshooting
- The device does not turn on. Possible cause: There is no power coming from the power outlet. Solution: Test the outlet by plugging another device into it.
- The kettle switches off a few seconds after it is switched on. Possible cause: low water level in the kettle. Solution: Turn off and unplug the device. Wait for the kettle to cool down and follow the instructions under “Boiling” in the “Operating the device” section.
An attempt to connect the device to the AENO application failed. Possible
reason: no Wi-Fi signal. Solution: Check for a Wi-Fi signal.
ATTENTION! If your problem persists, please contact your local supplier
or the service center for support. Please do not disassemble the device or try
to repair it on your own.
ASBISc reserves the right to modify the device and to make changes and
additions to this document without prior notice to users.
The warranty period and service life is 2 years from the date of retail sale
of the product.
Manufacturer’s information: ASBISc Enterprises PLC, Iapetou, 1, Agios
Athanasios, 4101, Limassol, Cyprus. Made in China. All trademarks and names
herein are the property of their respective owners. Up-to-date information and
a detailed description of the device, as well as connection instructions,
certificates, information about companies that accept quality claims and
warranties, are available for download at
aeno.com/documents.
SIMPLIFIED DECLARATION OF CONFORMITY. Hereby, ASBISc declares that the device
is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
aeno.com/userfiles/files/Certificates/CE/EK7S.pdf.
Recycling information
This symbol indicates that you must follow the Waste Electrical and Electronic
Equipment (WEEE) and Waste Battery and Battery Regulations when disposing of
the device, its batteries and accumulators, and its electrical and electronic
accessories. According to the rules, this equipment must be disposed of
separately at the end of its service life. Do not dispose of the device, its
batteries and accumulators, or its electrical and electronic accessories
together with unsorted municipal waste, as this will harm the environment. To
dispose of this equipment, it must be returned to the point of sale or turned
in to a local recycling facility. You should contact your local household
waste disposal service for details.
Device name: __
Serial number:
Purchase date:
Seller stamp:
Download the full warranty card on aeno.com
Please contact our online support team if you have any questions or issues
with your AENO device.
This is a better option than visiting the store and will save you time and
effort
Get support
References
- Home appliances AENO - Smart home appliances on the official website of the manufacturer AENO in Europe
- ИнÑтрукции за Ñвързване | AENO в БългариÑ
- Upute za povezivanje | AENO u Bosni i Hercegovini
- Pokyny pro připojenà | AENO v České republice
- Anschlusshinweise | AENO in Deutschland
- Documents | AENO in Europe
- Instrucciones de conexión | AENO en España
- Csatlakozási útmutató | AENO Magyarországon
- Aansluitingsinstructies | AENO in Nederland
- Dokumenty | AENO w Polsce
- Instrukcja podłączenia | AENO w Polsce
- Instrucțiuni de conectare | AENO în România
- Connecting instructions | AENO in Europe
- Service and Warranty | AENO in Europe
- Dokumenty | AENO v Slovinsku
- Návod na pripojenie | AENO na Slovensku
- ІнÑÑ‚Ñ€ÑƒÐºÑ†Ñ–Ñ Ð· Ð¿Ñ–Ð´ÐºÐ»ÑŽÑ‡ÐµÐ½Ð½Ñ | AENO в Україні
- ИнÑтрукции за Ñвързване | AENO в БългариÑ
- Pokyny pro připojenà | AENO v České republice
- Anschlusshinweise | AENO in Deutschland
- Instrukcja podłączenia | AENO w Polsce
- Instrucțiuni de conectare | AENO în România
- Connecting instructions | AENO in Europe
- ИнÑтрукции по подключению | AENO
- Návod na pripojenie | AENO na Slovensku
- ІнÑÑ‚Ñ€ÑƒÐºÑ†Ñ–Ñ Ð· Ð¿Ñ–Ð´ÐºÐ»ÑŽÑ‡ÐµÐ½Ð½Ñ | AENO в Україні
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>