VEVOR DGBMD8-8L110VTTM3V1 450 W Dual Rotating Dough Kneading Machine Food Processors Instruction Manual
- October 26, 2023
- VEVOR
Table of Contents
DGBMD8-8L110VTTM3V1 450 W Dual Rotating Dough Kneading Machine Food
Processors
Instruction Manual
BMD8 SERIES SPIRAL MIXERS
Frigidaire Gallery Refrigerator Rev...
Frigidaire Gallery Refrigerator Review
BMD8 series spiral mixers are a new type of kneader. Both the dough arm and bowl are running so that it can raise the mixing speed and efficiency greatly. The machines are equipped with protective covers, are easily operable, and safety. They are good-looking and easy clean, suitable for mixing flour in hotels, restaurants, and public canteens.
Technical specifications
Model| Voltage| Frequency| Power| IP Rating| Bowl
volume| Max capacity| Dimension mm
---|---|---|---|---|---|---|---
BMD8| —110V| 60Hz| 0.45kW| IPX1| 8L| 3kg| 495x302x385
Operation and Notes
- Set it on a dry horizontal plane (or support), and take it firmly.
- Before use, ensure that the power supply corresponds to that required by the machine and the external ground wire is reliably connected.
- Ensure that flour mixing capacity is lower than the max. flour capacity.
- Before starting, ensure that a safe protection cover has been put down.
- Do not put your hands and hard things into the bowl in running.
- Do not hold and drag the belts and chains by hand.
Maintenance
- Continuous run time is not too long, keep the machine used long.
- After use, clean the machine, as to avoid bacteria growth.
- The transmission case is packed with special grease that will last for service for six months. To add or replace grease, it is necessary to remove the upper cover.
Note: Before maintenance, the machine must be cut off from the power supply.
Troubleshooting:
| Trouble | Probable cause | Remedy |
|---|---|---|
| The mixing shaft does not rotate after switching on | Electric connectors are | |
| loose | Check the electric circuit tighten those |
loose connectors
Square rod tremble| Lock bolts are loose| Tighten those bolts
The temperature rise of the motor is too
high, below the speed| Lack of voltage| Check the supply voltage
Overload| Less load
The noise of the transmission case is serious| Lubrication is insufficient|
Add or replace the grease
Chains are loose| Tighten the chains
The agitator knocks with the bowl| The agitator of the bowl is deformed|
Repair or replace deformed part
Warning: It cannot be cleaned by water directly.