IsEasy 18594 Wall Mount Cooker Hood User Manual
- June 12, 2024
- IsEasy
Table of Contents
IsEasy 18594 Wall Mount Cooker Hood
Product Information
The product is a range hood with the following specifications:
- Voltage/Frequency: 120V/60Hz
- Input Power: 88w
- Input Current: 0.8A
- Lamp Max Power: 2*1.5W
- ETL NO: TD1775Y-AC-I1
Product Usage Instructions
- Make sure the power cord is plugged into a 120V power outlet.
- Turn on the range hood using the power switch.
- Adjust the fan speed and lighting as desired using the control buttons.
- To replace the lamp, follow these steps:
- Turn off the range hood and unplug it from the power outlet.
- Locate the lamp housing and remove the cover.
- Take out the old lamp and insert a new one of the same specifications (2*1.5W).
- Replace the lamp housing cover.
- Clean the range hood regularly to maintain its performance. Refer to the user manual for detailed cleaning instructions.
- Do not attempt to replace or cut the power cord. If there is any issue with the power cord, contact customer support for assistance.
If you need further assistance or have any questions, please contact our customer support via email at service@iseasy.com or visit our website at www.iseasy.com.
Introduction
Thank you for choosing this cooker hood.
This instruction manual is designed to provide you with all required
instructions related to the installation, use and maintenance of the
appliance. In order to operate the unit correctly and safely, please read this
instruction manual carefully before installation and usage.
Safety precaution
- Never let the children operate the
- The cooker hood is for home use only, not suitable for barbecue, roast shop and other commercial purpose.
- Clean the cooker hood after the specified time (suggestion: every 2 months) according to the instruction manual and keep the unit from danger of burning. There is a fire risk if cleaning is not carried out in accordance with the
- Please keep the kitchen room with good convection before connecting this appliance; please check that the power supply cord is undamaged. A damaged supply cord must be replaced by qualified service personnel only.
- Regulations concerning the discharge of air have to be
- This appliance can be used by children aged from 8 years and above and also the persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels;the range hood is only intended to be installed over a hob with no more than four hob elements; The air must not be discharged into a flue that is used forexhausting fumes from appliances burning gas or other fuels.
Accessible parts may become hot when used with cooking appliance.
Electrical Shock Hazard
Only plug this unit into a properly earthed outlet. If you have doubts,
seek advice from a suitably qualified engineer.
SPECIFICATION
COMPONENTS
INSTALLATION
Prepare for installation
-
If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or non-flammable material with an interior diameter of 5.9″). Choose a straight, short duct run to allow the hood to perform most efficiently. Long duct runs, elbows and transitions will reduce the performance of the hood. Use as few of them as possible. When possible, use at least 2 foots straight runs bef re any turns. Larger duct work may be required for best performance with longer duct runs. If you don’t have an outlet to the outside, you can go with recirculation mode by using charcoal filters.
-
Before installation, turn the unit off and unplug it from the outlet.
Note : The power cord is 34.3″ in . It is not recommended that user replace the power cord or cut the power cord. -
The cooker hood should be placed at a distance of 25.6″~29.5 for best effect.
NOTE : Please connect the power supply to test and confirm that the power is on before installing this cooker hood.
Install the hood
- Place the mounting bracket for the hood body on the wall at the desired position, mark the position of the screw holes and drill 3 holes qi 31″ at the marked positions.
- Fix the bracket to the wall using the screws anddowels supplied
- Lift the hood body and attach it to the wall
- Remove the aluminum grease filter.
- Mark the two holes in the rear side of the hood on the
- Take the hood down again and drill two ¢i 31″ holes at the marked points.
- Hang up the hood body again and fix the rear side to the wall using the screws and dowels
- Attach the chimney brackets for the outer (lower) and inner (upper) part of the shaft to the corresponding positions on the exhaust shaft using the screws supplied
- Place the exhaust shaft on the hood body, pull out the inner part of the shaft to the desired height and mark the position of the screw holes in the chimney brackets on the wall.
- Remove the exhaust shaft and drill the holes at the marked
- For exhaust air operation of the hood, attach the exhaust hose to the air outlet of the hood
- Re-attach the exhaust shaft onto the hood body, passing the exhaust hose through the shaft and connecting it to the exhaust opening if needed.
- Fasten the two shaft parts with the chimney brackets onto the wall with 2 screws (0.16″*1.18″) each.
- Make sure that the lower end of the outer shaft part rests on the hood It is not necessary to screw the shaft to the hood body.
OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen
Push Button
MAINTENANCE
Before cleaning switch the unit off and pull out the plug.
Regular Cleaning
- Use a soft cloth moistened with hand-warm mildly soapy water or household cleaning detergent.
- Never use metal pads, chemicals, abrasive material or stiff brushes to clean the unit
Bulb Replacement
- Switch the unit off and unplug the appliance.
CAUTION : The Led may be hot leave it 10 minutes before replacement
Aluminum and carbon filter replacement:
In order to install the carbon filter, the grease filter should be detached
first. Press the lock and pull it downward.
Aluminum filters:
To avoid fires, clean thoroughly once a month or whenever the display pilot
lights up (if fitted). To do so remove the filters and soak in hot water and
detergent for an hour.If using a dishwasher,position the filters vertically to
improve the cleaning process.
Installation :
Fix carbon filter into the unit and turn it in clockwise direction. Repeat the
same on the other side.
Important Notice:
- Make sure the filter is securely locked. Otherwise, it would loosen and cause abnormal noise and danger.
- Using carbon filter would reduce the airflow of the range hood.
Carbon filter life time:
Suggest changing to new one every 3 months (According to different kitchen
condition, the life time of carbon filter might be longer or shorter than 3
months).
TROUBLESHOOTING
| Fault | Cause | Solution |
|---|
Light on,but fan does not work
| The fan blade is jammed.| Switch off the unit and repair by qualified service personnel only.
The motor is damaged.
Both light and fan do not work
|
Light bulb burn.
| Replace the LED light with correct rating.
Power cord is loose.
| Plug into the power supply again.
Serious Vibration of the unit
| The fan blade is damaged.|
Switch of the unit and repair by qualified service personnel only.
The fan motor is not fixed tightly.
The unit is not hung properly on the bracket.
|
Take down the unit and check whether the bracket
Suction performance not good| Too far distance between the unit and the cooktop.| Readjust the distance between 25.6″~29.5″.
ENVIRONMENTAL PROTECTION
- While unpacking, the packaging materials (polythene bags, polystyrene pieces,etc.) should be kept away from CHOKING HAZARD!
- Old and unused appliances must be sent for disposal to the responsible recyclingcentre. Never expose to open flames.
- Before you dispose of an old appliance, render it Unplug the appliance and cut off the entire power cord. Dispose of the power cord and the plug immediately,
- Dispose of any paper and cardboard into the corresponding contain
- Dispose of any plastics into the corresponding containers.
- If suitable containers are not available at your residential area, dispose of these materials at a suitable municipal collection point for waste-recycling.
- Receive more detailed information from your retailer or your municipal facilities.
WARRANTY
Customer Support Email: service@iseasy.com Website: www.iseasy.com
RANGE HOOD
- Voltage/Frequency: 120V/60Hz
- Input Power: 88w
- Input Current: 0.8A
- Lamp Max Power: 2*1.5W
- ETL NO: TD1775Y-AC-I1
CONFORMS TO UL STD.507 CERTIFIED TO CSASTD.C22.2 NO.113
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>