SENSOR 35059308 SEP 540 BT Wireless Earphone with a Microphone User Manual
- June 16, 2024
- Sensor
Table of Contents
SENSOR 35059308 SEP 540 BT Wireless Earphone with a Microphone
Supply content
- “L” and “R” earphone
- Charging case
- User’s manual
- USB-C charging cable
SEP 540 BT Bluetooth earphones description
- Earphone touch pad
- Microphone and earphone charging contacts
- Earphone LED indicator
- Earphone charging contacts in the case
- Charging case LED indicator
- USB-C charging connector
- Right earphone
- Left earphone
Left and right earphone function
Long touch – turn off/on the earphone
1 x long touch (2 seconds) during an incoming call – call rejection
1 x short touch during an incoming call – answer the call
1 x short touch during an ongoing call – end call
1 x short touch – plaid function
1 x short touch – pause function
3 x short touch – launch SIRI/Google assistant
Left earphone
Long touch in music mode – reduce volume bid one level 2 x short touch – previous track
Right earphone
Long touch in music mode – increase volume bid one level 2 x short touch – next track
Putting into operation
Before first use, be sure to read the safety instructions contained in this
user’s manual carefully.
Before using the earphones for the first time, put the earphones in the
charging case and connect the charging adapter. Wait until the charging case
and earphones are fully charged.
Turn ing on the earphones – Taking the earphones out of the case will
automatically switch them on. When the earphones are in the off state outside
the charging case. Press and hold the touch pad on
each earphone and wait for the earphones to switch on.
Turning off the earphones – Inserting the earphones into the charging case
will automatically turn off the earphones. Long press and hold the touch pad
of the earphones until the earphones turn off. Pairing the earphones with each
other – The earphones are already d paired from the factory and do not need to
be paired with each other. (If pairing to TWS mode fails, return the earphones
to the charging case and repeat the above instructions).
Warning: To prevent damage to your hearing, always keep the volume level
of your device to a minimum before connecting BT earphones to your mobile
1device. Keep the touch pad clean and avoid touching other objects or body
parts such as hair. Note: If the BT earphones are not paired with any device,
they will turn off when left idle for a long time. Put them in the case.
Pairing your earphones via Bluetooth
To pair the BT earphones with your mobile device, do the following:
Remove the earphones from the charging case (blue and red intermittent
earphone indication) and look for the Bluetooth earphone name “SEP 54OBT” in
the device your want to pair and start the pairing process. Always perform the
pairing process when both earphones are removed from the charging case. If
your are requested to enter a pairing code while your device and the BT
earphones are pairing, use the following code: “0000”.
To cancel the pairing process, disconnect the BT earphones from your mobile
device (cancel the Bluetooth pairing).
Remark: To ensure a stable Bluetooth connection, make sure that the distance
between the BT earphones and your paired device is kept within 10 meters.
Depending on ambient interference, in some cases it may be necessary to
maintain a shorter distance between the BT earphones and the paired device.
Charging
A charged battery provides power for several hours of operation at normal
volume levels. A high volume consumes more battery power; therefore, we
recommend listening at normal volume levels. When the BT earphones are placed
in the charging case, the led indicators show:
a. The blue continuous indication of the earphones indicates charging.
b. When the USB-C charging cable is connected, the intermittent l orange
indication shows the charging of the charging case. A fully charged charging
case indicated bid an orange solid indication.
Attention: For charging, use only the original accessories supplied with
the appliance. To achieve maximum battery life, it is advisable to start
charging the battery only when the battery is low (10% – 20%). Charge
continuously until fully charged.
Recommendation: If ld0ur earphones are not to be used for an extended period
of time, we recommend to fully charge the batteries once every two to three
months. We recommend to store the BT earphones and the charging box with the
battery charg1ed to prevent irreparable damage to the battery (loss of
capacity
Specification
Bluetooth Version : 5.0
Bluetooth Profile : HSP, HFP, A2DP, AVRCP
Speaker Diameter: 13mm X 2pcs
Impedance: 32Ω±10 %
Frequency range: 20 Hz – 20 kHz
Sensitivity : 120dB±3 dB /1 mW (S.P.Lat 1 KHz)
Microphone Sensitivity: -38dB±3dB
Earbud Battery 3.7V, 25mAh Li-po Battery
Base Battery: 230mAh Li-po Batter(d
Earbud Continuous Playing time: 3 hrs per full charged
Charging time: 1.5 hrs for Base, 1.5 hrs for Earbuds
Charging Port: Type-C
Safety Notice
Please observe the rules of the Country or Region which your are in while
driving.
Do not disassemble or modify the headset at any reason, otherwise, It maid
damage or burn the headset.
If tl1ere is any quality problem, please send l1eadset to authorized service
center for repairing.
Please keep the equipment along with all the accessories out of the reach of
children and pets.
Extreme temperatures will cause the device deformation, reduce the charging
capacity and shorten the working life.
Please do not immerse the earphone into water. Guarantee will be lost if
damage is caused by immersed into water.
It will damage (dour hearing if you listen with high volume for a long time.
It is recommended that only use the lowest volume which is necessary for
speaking and listening to music.
Instructions and information regarding the disposal of used packaging materials
Dispose of packaging material at a public waste disposal site.
Disposal of used electrical and electronic appliances
The meaning of the symbol on the product, its accessory or packaging indicates
that this product shall not be treated as househol1d waste. Please, dispose of
this • product at your applicable collection point for the recycling of
electrical & electronic equipment waste. Alternatively in some states of the
European Union or other European states you may return your products to your
local retailer when buying an equivalent new product. The correct disposal of
this product will help save valuable natural resources and help in preventing
the potential negative impact on the environment and human health, which could
be caused as a result of improper liquidation of waste. Please ask your local
authorities or the nearest waste collection centre for further details. The
improper disposal of this type of waste may fall subject to national
regulations for fines.
For business entities in the European Union
If you wish to dispose, of an electrical or electronic device, request the
necessary information from your seller or supplier.
Disposal in other countries outside t he European Union
If you wish to dispose of this product , request the necessary information
about the correct disposal method from local government departments or from
your seller. This appliance complies with EU rules and regulations regarding
electromagnetic and electrical safety. Changes to the text. design and
technical specifications may occur without prior notice and we reserve the
right to make these changes.
Hereby, FAST CR, a.s. declares that the radio equipment type SEP 540 BT is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.sencor.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>