KICHLER 45887BK Winslow Wall Mt Bath 4 Arm Wall Light Instruction Manual
- June 15, 2024
- KICHLER
Table of Contents
KICHLER 45887BK Winslow Wall Mt Bath 4 Arm Wall Light
CAUTION – RISK OF SHOCK
Disconnect Power at the main circuit breaker panel or main fuse box before starting and during the installation.
WARNING:
This fixture is intended for installation in accordance with the National
Electrical Code (NEC) and all local code specifications. If you are not
familiar with code requirements, installation by a certified electrician is
recommended.
Overview
CLEANING
- Always be certain that electric current is turned off before cleaning.
- Only a soft damp cloth should be used. Harsh cleaning products may damage the finish.
-
Find the appropriate threaded holes on mounting strap[1] that align with hole distance in canopy[2] Thread mounting screws[3] into threaded holes starting from the outlet box[4] side.
-
Attach mounting strap to outlet box with strap mounting screws[5]. Mounting strap can be adjusted to suit position of fixture.
-
Grounding instructions: (See Illus. A or B)
A ) On fixtures where mounting strap is provided with a hole and two raise dimples, wrap ground wire from outlet box around green ground screw, and thread into hole.
B ) On fixtures where a cupped washer is provided, put ground wire from outlet box under cupped washer and green ground screw and thread screw into hole in mounting strap.
If fixture is provided with ground wire, connect fixture ground wire to outlet box ground wire with wire connector after following the above steps. Never connect ground wire to black or white power supply wires.
-
Make wire connections. Reference chart below for correct connections and wire accordingly.
Connect Black or Red Supply Wire to:| Connect White Supply Wire to:
---|---
Black| White
Parallel cord (round & smooth)| Parallel cord (square & ridged)
Clear, Brown, Gold or Black without Tracer| Clear, Brown, Gold or Black with Tracer
Insulated wire (other than green) with copper conductor| Insulated wire (other than green) with silver conductor
*Note: When parallel wire (SPT 1 & SPT 2) are used. The neutral wire is square shaped or ridged and the other wire will be round in shape or smooth (See illus.)|
-
Push fixture to wall carefully passing mounting screws with holes in canopy.
NOTE: Make sure all wires are inside canopy and do not get pinched between wall and canopy of fixture. -
Use the lock washers[10] and then the knobs[6] to secure fixture to wall. Tighten to secure.
-
Carefully raise glass[7] to the fixture. Slip the smaller opening over the socket[8] and fit the glass against the socket.
-
Thread the socket ring[9] onto the socket. Tighten socket ring to secure glass in place DO NOT OVER TIGHTEN.
-
Insert recommended bulb (not supplied).
-
Repeat steps 7-9 for remaining sockets.
CUSTOMER SUPPORT
For warranty information please visit:
kichler.com/warranty
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>