ORTECH VT-40W Series LED Vapour Tights Instruction Manual
- June 4, 2024
- Ortech
Table of Contents
ORTECH VT-40W Series LED Vapour Tights
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Vapour Tight can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to prevent electric shock
- Any non-professionals are not allowed to disassemble the lamp
APPLICATION NOTICE
- DO NOT cover the fixtures with flammable materials
- Lamps should always be installed or replaced with care
- Misuse of, or changes to the fixture shall nullify the guarantee
- Before installing the lighting fixtures, please read this instruction manual carefully
- When a lamp is to be cleaned, make the power off and let it cool down completely. Clean the fixture with a soft cloth and a standard PH-neutral detergent
- Check the local voltage in accordance with the product requirements before using the product. Exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard
- The lighting fixtures should be installed, connected and tested by a certified installer based on the local regulations
- Re-lamping only can be done when the power is off and the lamp is completely cooled down
CAUTION
PLEASE READ THE INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician. Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
INSTALLATION GUIDE
- Keep power switches off. (see fig.1)
- Drill four 6 mm cutting holes according to below the cutting size instructed (see fig.2)
- Put plastic steel cork into the cutting holes properly
- Lock the claps onto the ceiling with self-taping screws (see fig.3)
- Put the lamp into the claps properly (see fig.4)
- At the rear side of the led fixture, please connect the live (L) and Neutral (N) terminals are used for connecting to power output. Please follow the standard process to connect them accordingly and do insulation on both terminal respectively (see fig.5) Check accuracy, and then turn on the power for use.
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.
13376 Comber Way
Surrey BC V3W 5V9
info@ortechindustries.com
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
1-888-543-6473
1-888-541-6474
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>