BOYA Blue Deep Wireless Hand Mic Instructions
- June 4, 2024
- Boya
Table of Contents
Wireless Instructions
INSTRUCTION
A. Display, Screen
B. On/Off Switch
C. Battery Compartment
D. Channel Adjustment Button Wireless microphone battery installation and
on/off: |
- Take down the tail tube(C) of the mic.
- Put two AA batteries into the battery _ compartment of the microphone according to the positive and negative poles.
- Press the power button (B) to turn on the microphone.
Operating instructions for wireless microphone finding:
The 5 Frequencies of Mic A: CHO1-CH15
The 5 frequencies of Mic B: CH16-CH30
Press the “D” button to switch channels in sequence.
Cautions : The operating distance of the wireless microphone is within
100ft.
In order not to affect performance, please do not exceed this range.
When the battery power is low or the environmental interference source is too
strong, the operating distance will be shortened.
Do not use wireless microphones of the same channel simultaneously in a short
distance, as this will cause silence or interference.
If you have purchased two or more sets of this product and plan to use them
together within a short distance, please switch the wireless microphone to a
different channel. During use, please do not place the machine near devices
with high interference frequencies (such as VCD/ com DVD). so as to avoid
interference between the machine and the VCD (CD/DVD of the same frequency.
PAIRING STEPS
- Please turn off the receiver and the microphone first.
- Unscrew the microphone tail tube and install the battery into the mic’s battery compartment.
- Long press button @ under shutdown state, do not release it, simultaneously press the power button @ until the screen flashes quickly, then release the buttons synchronously (the HI/LO button and the power button are released synchronously).
- Turn on the receiver power switch, after 5 seconds, press the HI/LO button@ on the microphone. If the screen of the microphone is not flashing, and the frequency is not only displayed on the microphone screen, but also on the receiver, which means the pairing is successful.
- Turn off the microphone, then tighten the microphone tail tube. The microphone pairing is completed.
TECHNICAL PARAMETERS
Wireless microphone:
Frequency Response: 50Hz-15kHz
Operating Distance: 100ft
RF Carrier Stability: +0.003%
S/N Ratio: 96dB
T.H.D.: <0.5%@1kHz
Microphone Input Sensitivity: -52dB
RF Sensitivity: -95dBm
Working temperature: 0C to +55C
FCC STATEMENT
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,and
(2) This device must accept any interference received, including interference that may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by ons or more of the following measures: Reorient
or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>