CARBEST 80286 Automatic 7stage Smart Charger Instruction Manual

CARBEST 80286 Automatic 7stage Smart Charger Instruction Manual

IMPORTANT INFORMATION

Thank you for purchasing our smart battery charger. Please read this instruction manual carefully before operating the device. Keep this manual in a safe place for future reference. This instruction manual is part of the product. It must be handed over along with the device if it is passed on to a third party.

INTRODUCTION

This compact smart battery charger uses the latest switch-mode technology and is designed particularly to charge lead-acid batteries in dual battery system to their best level. The automatic 7 stage charging algorithm delivers a much faster, efficient and full charge without the issue of voltage drops.

Thanks to the boost-charging feature, this helps activate the battery status and wake up a weak or flat battery to a suitable recharging level. This also improves the charge delivered to your battery, increasing battery life and saving on premature battery failure.

This smart battery charger can be used charging for LITHIUM/GEL/AGM/WET batteries by press the mode selection button. And this smart battery charger can be used as a constant power supply to run accessories that require a stable and clean DC voltage. For safety reasons, the input and output of the charger is completely isolated and the batteries are protected for overcharged.

The cooling fan is thermal & charge current dual controlled, when temperature reach up to 45 degrees or when charge current up to 2 A, the cooling fan start working. It will switch on and off automatically to control the internal temperature of the unit.

Only when this smart battery charger connects to battery, then the charger has DC output start to charge. Note: it is a touch-type battery charger, the first start battery voltage for constant current mode need up to 12.6 V.

DC short circuit protection: after short circuit protection, cutoff the DC output, LCD display »-P-«, after short circuit release auto. Reset.

Over heat protection: when temperature up to 75+/- 5°C, LCD display »-P-«, when temperature down auto. Reset.

WARNING Risk of electric shock! Do not open the device if it has been connected to the AC power source.

This device has been CE tested and conforms to the applicable directives and standards.

THE BATTERY CHARGER MATERIALS LIST AND INDICATION

There are smart charger unit, user manual, AC power cable and spare fuse inside of packing.

1. Battery Charging Output
2. LCD Display
3. AC Input Terminal
4. Power ON/OFF Switch
5. Cooling Fan
6. Mounting Hole
7. AC Power Cable
8. Fuse

THE LCD SCREEN DISPLAY AND BUTTON FUNCTION

1. Charging voltage LED: if you want to know charging voltage, please press the status selection button until the charging current LED light on, then LCD screen display the charger charging voltage.
2. Charging current LED: If you want to know charging current, please press the status selection button until the charging current LED light on, then the LCD screen display the charger charging current.
3. Charging stage LED: If you want to know the charger in which charging stage, please press the status button until the charging stage LED light on, then the LCD screen displays the charger in which charge stage. There are total 7 different charge stages.
4. Status selection button: By long press the »status selection« button to change the LCD screen display the charging voltage, charging current or different charge stages.
5. Switching power supply LED: if you want to use this charger as a switching power supply unit, please press the mode selection until the switching power supply LED light on. There are two colors in switching power supply mode: red- 13.4 V, orange- 13.8 V.
6. Lithium battery mode: press the MODE SELECTION until the Lithium battery mode light GREEN light if you want to charge a Lithium battery.
7. GEL/AGM/WET batteries charging LED: by press the mode selection button to setting the battery type.
8. Mode selection button: by long press this button to change this smart charger to switching power supply function or setting LITHIUM, GEL, AGM or WET batteries type.
9. LCD screen display: it shall display auto. circularly the charging voltage, current and different charging stage by numbers. When overheat and short circuit protection, the LCD displays »-P-«. It shall display 60s, and then auto. Off. Press the button, then auto. display.

7-STAGE AUTOMATIC CHARGING
This is a fully automatic battery charger with 7 charge stages.

Automatic charging protects your battery from being overcharged. So you can leave the charger connected to the battery indefinitely.

7-stage charging is a very comprehensive and accurate charging process that gives your battery longer life and better performance compared to using traditional chargers.

7-stage chargers are suitable for most battery types including LITHIUM, GEL,
AGM, WET batteries. They may also help restore drained and sulphated batteries.

The 7 stages are:

Desulphatlon: the desulphation stage may break down sulphation that occurs in batteries that have been left flat for extended periods of time, returning them back to full charge. Sulphation occurs when lead-sulphate hardens and clogs up to battery cells.

Soft start: A preliminary charge processes that gently introduces power to the battery. this protects the battery and increase battery life.

Bulk charge: charging wlth maximum current until approximately 80% battery capacity. Absorption: charging with declining current to maximize up to 100% battery capacity.

Absorption: charging with declining current to maximize up to 100% battery capacity.

Battery test: tests the battery whether can save power, if unable battery may need replacing.

Recondition: choose the recond program to add the recond step to the charging process. During the recond step voltage increases to create controlled gasing in the battery. Gasing mixes the battery acid and gives back energy to the battery.

Float: the float stage maintains the battery at 100% charge without overcharging or damagjng the battery. This means the charger can be left connected to the battery indefinitely. The battery charger has an 7– 5 stage fully automatic charging curve, the cycle is repeated infinitely. lf the terminal voltage drops below a lower limit, the charger automatically goes back to the begjnning of the charging curve.

CAUTION!

The device is for indoor use, do not use the device near flammable materials or in any location that may accumulate flammable fumes or gasses.

Appliance shall only be used with rated voltage and frequency.

Hot surface when operating, especially at full load condition.

Make sure the polarity is correct.

Do not locate the device on the top of the battery. Especially wet type battery. it may generate gas vapor while charging.

Do not charge non-rechargeable batteries.

Use the appliance only in the described manner.

Do not expose the device to a heat source, such as direct sunlight or heating.

Store the device in a dry and cool place.

Do not open, No any user serviceable parts inside.

USING STEPS

1. First connect to the battery, switching on the charger, then charge start  to charge for the battery. It is with 7-stage charge function. The LCD display auto. circularly. When overheat and short circuit protection, The LCD screen display »-P-«.

2. The LCD screen display 60s, then auto. Off. Press the button, then auto. display.

3. Long press the button »mode selection« to change the mode.
   Note: there are three colors of indicators in lithium battery mode: Green-lithium battery mode, switching power supply mode with: red – 13.4 V and orange – 13.8 V

4. By press the »status selection« button to change the LCD display.

TROUBLE SHOOTING

Select the correct battery Battery cable con- nected to the battery is too thin Change cable of proper size Replace new battery

battery
Output short circuit
Battery charging not stable| AC input voltage is not stable| Check input AC volt- age if it is within the input voltage range
Not choose the correct battery type
Charger cannot switch to float
Battery in precondition

SAFETY OPERATION

• If cables have to be fed through walls with sharp edges, always use tubes or ducts to prevent damage.
• Do not pull on the cables, fasten the device and cable securely. Lay the cable so that it cannot be tripped over.
• Ensure the device is standing firmly that it cannot tip over or fall down.
• Children should be supervised to ensure that they do not play with the device.
• Do not allow water to drip or splash on the device.
• Make sure the air inlets and outlets of the device are not covered.
• Operate the device only if you are certain that the hosing and connection cables are undamaged.
• Do not reverse the polarity of the connection to the battery.
• Disconnect the supply before making or breaking the connections to the battery

WARNING Risk of electric shock! Do not open the device if it has been connected to the AC power source.

SPECIFICATION

28.4 V/29.2/29.6 V DC selectable (24 V)
14.4V ± 0.2V (12V), 28.8V ± 0.4V (24V) (LITHIUM Mode)
Floating Charging| 13.2 V/13.5/13.8 V DC selectable (12 V)
26.8 V/27 V/2.6 V DC selectable (24 V)
13.5V ± 0.2V (12V), 27V ± 0.4V (24V) (LITHIUM Mode)
Protection Function| Reverse polarity, output short-circuit, over current, over voltage, overload, over heat
Charging way| Automatic 7-Stage Charging: Desulphation, soft start, bulk, absorption, battery test, recondition and float
LED Display| (U-I-C-P) battery voltage, output current, charge status, overheat protection
Battery type| All rechargeable LITHIUM, AGM, GEL and WET battery
Operating Temperature| 0 – 40 °C
Ventilation| Cooling fan; By thermal & current control
Efficiency up to| 88 %
Isolated DC output| 2
Dimension (mm)| 176 x 175 x 95 (L x W x H)
N.W/ Unit| 1310 g
QTY/Ctn| 6 pcs/box. 42.5 x 28 x 37.5 cm
G.W. /Ctn| 12 kg

WARRANTY

The warranty period is 36 months. Reimo reserves the right to rectify eventual defaults. The guarantee is excluded for all damages caused by faulty use or improper handling.

Liability limitations : In no case Reimo will be reliable for collateral-, secondary- or indirect damages, costs, expenditure, missed benefits or missed earnings.

The indicated sales price of the product is representing the equivalent value of Reimo’s liability limitations.

DISPOSAL

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-beeing. When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposals at least free of charge.

REIMO REISEMOBIL-CENTER GMBH
63329 EGELSBACH · BOSCHRING 10
GERMANY · WWW.REIMO.COM
MADE IN CHINA · © 01/2022

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>