BOYA BY-WS1000 Windshield and Suspension System for Shotgun Microphone Instruction Manual

BOYA BY-WS1000 Windshield and Suspension System for Shotgun Microphone Instruction Manual

Product Structure

Adjustment

Handle angle

1. Initial default angle

2. Loosen the knob and adjust to desired angle

3. Tighten the knob after adjustment

Handle Position

Operations

1. Unscrew and remove the rear dome
   Clockwise to tight, counter clockwise to loose
   

2. Loosen the front and rear knobs

3. Slide the suspension body out of the main blimp housing

4. Loosen the locking knobs to adjust position of shockproof rings
   

5. Place the microphone
   NOTE: Fits up to 320mm in length and 919-22mm shotgun microphone
   

6. Connect the XLR plug
   

7. Place the suspension body back into the main blimp housing

8. Slide in and align the rails with the main blimp housing
   

9. Tighten the front and rear knobs

10. Place the cable into the slot
    

11. Replace and screw the rear dome

12. Using the fur windshield

13.  Loosen the drawstring of fur windshield and stretch over the blimp body
    

14. Straighten the fur windshield, than tighten and lock the drawstring

Using indoor

Using indoor without main blimp housing

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>