RF Solutions FERRET-8S1 FERRET 1 Channel System User Guide
- June 4, 2024
- RF SOLUTIONS
Table of Contents
RF Solutions FERRET-8S1 FERRET 1 Channel System
Hereby, RF Solutions Limited declares that the radio equipment type defined within this document is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.rfsolutions.co.uk
Disclaimer
Whilst the information in this document is believed to be correct at the time
of issue, RF Solutions Ltd does not accept any liability whatsoever for its
accuracy, adequacy or completeness. No express or implied warranty or
representation is given relating to the information contained in this
document. RF Solutions Ltd reserves the right to make changes and improvements
to the product(s) described herein without notice. Buyers and other users
should determine for themselves the suitability of any such information or
products for their own particular requirements or specification(s). RF
Solutions Ltd shall not be liable for any loss or damage caused as a result of
user’s own determination of how to deploy or use RF Solutions Ltd’s products.
Use ofRF Solutions Ltd products or components in life support and/or safety
applications is not authorised except with express written approval. No
licences are created, implicitly or otherwise, under any of RF Solutions Ltd’s
intellectual property rights. Liability for loss or damage resulting or caused
by reliance on the information contained herein or from the use of the product
(including liability resulting from negligence or where RF Solutions Ltd was
aware of the possibility of such loss or damage arising) is excluded. This
will not operate to limit or restrict RF Solutions Ltd’s liability for death
or personal injury resulting from its negligence.
Safety Information
Carefully read the following safety information before proceeding with installation, operation, or mainte-nance of RF Solutions product. Failure to follow these warnings could result in death or serious injury
- This radio system must not be used in areas where there is a risk of explosion.
- Only qualified personnel should be permitted to access the transmitter and operate the equipment.
- Always follow operating information as well as all applicable safety procedures and requirements.
- You must satisfy the age requirements in your country for operating the equipment.
- Store in a safe place.
- Keep a clear view of the work area at all time before using, check it is safe to do so Before maintenance intervention on any remote controlled equipment
- Do not open the receiver enclosure unless you are qualified.
- Disconnect all electrical power from the equipment.
Battery Precautions
- Risk of explosion if battery is replaced with a battery of an incorrect type.
- Do not short-circuit, disassemble, deform or heat batteries.
- Never attempt to charge a visibly damaged or frozen battery.
- Do not use or charge the battery if it appears to be leaking, deformed or damaged in any way.
- Immediately discontinue use of the battery if, while using, charging, or storing the battery, the bat-tery emits an unusual smell, feels hot, changes color, changes shape, or appears abnormal in any oth-er way.
Electrical Safety
-
ISOLATE the mains electricity supply before removing the cover and observe any relevant safety infor-mation.
-
Maintenance to the product that involves removal of the cover should only be carried out by a compe-tent person or qualified electrician.
Ensure adequate protection on the Load circuit -
Refer to Product Datasheet for MAX operating Load.
-
Product must be installed in accordance with the local country electrical regulations.
-
A current limiting supply must be used in accordance with the datasheet
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives:
DO NOT Discard with normal waste, please recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU
Specifies certain limits for hazardous substances.
WEEE Directive 2012/19/EU
Waste Batteries and Accumulators Directive
2006/66/EC
Where batteries are fitted, before recycling the prod-uct, the batteries must
be removed and disposed of at a licensed collection point. RF Solutions
battery producer number: BPRN00060.
Waste electrical & electronic equipment. This product must be disposed of
through a licensed WEEE collection point. RF Solutions Ltd., fulfils its WEEE
obligations by the membership of an approved compliance scheme. Environment
agency number : WEE/JB0104WV.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>