RF Solutions SENW-DC-8T1 RIoT Wall Mount RF Door Contact Sensor User Guide
- June 5, 2024
- RF SOLUTIONS
Table of Contents
RF Solutions SENW-DC-8T1 RIoT Wall Mount RF Door Contact Sensor
Setup Procedure
- Open enclosure
- Activate sensor (from Standby)
- Learn sensor to RIoT-Hub
- Learn sensor to your smartphone/device
- Deploy
Note: The Switch/LED will operate at any time, but Sensor must be ACTIVE to Transmit any signal
Activate/Standby
Send a Learn Signal
Enter Config Mode
Tip:
To achieve optimum RF Transmission, mount the sensor ideally >1metre above
ground level.
Simplified Declaration of Conformity (RED)
Hereby, RF Solutions Limited declares that the radio equipment type defined within this document is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.rfsolutions.co.uk
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives: DO NOT Discard with normal waste, please
recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/EU
Specifies certain limits for hazardous substances.
WEEE Directive 2012/19/EU
Waste electrical & electronic equipment. This product must be disposed of
through a licensed WEEE collection point. RF Solutions Ltd. fulfills its WEEE
obligations by membership in an approved compliance scheme. Environment agency
number: WEE/JB0104WV.
Waste Batteries and Accumulators Directive 2006/66/EC
Where batteries are fitted, before recycling the product, the batteries must be removed and disposed of at a licensed collection point. RF Solutions battery producer number: BPRN00060.
Disclaimer
Whilst the information in this document is believed to be correct at the time of issue, RF Solutions Ltd does not accept any liability whatsoever for its accuracy, adequacy or completeness. No express or implied warranty or representation is given relating to the information contained in this document. RF Solutions Ltd reserves the right to make changes and improvements to the product(s) described herein without notice. Buyers and other users should determine for themselves the suitability of any such information or products for their own particular requirements or specification(s). RF Solutions Ltd shall not be liable for any loss or damage caused as a result of the user’s own determination of how to deploy or use RF Solutions Ltd’s products. Use of RF Solutions Ltd products or components in life support and/or safety applications is not authorized except with express written approval. No licenses are created, implicitly or otherwise, under any of RF Solutions Ltd’s intellectual property rights. Liability for loss or damage resulting or caused by reliance on the information contained herein or from the use of the product (including liability resulting from negligence or where RF Solutions Ltd was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict RF Solutions Ltd’s
References
- olutions.co.uk
- ons.co.uk
- RF Solutions | Remote control systems, RF Modules, Antennas
- rtsintercom.com/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>