scandomestic GUR 390 Freezer User Manual

GUR 390
GUF 390
User manual

Safety Tips

Position on a flat and stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
Health and Safety at Work Legislation
BS EN Codes of Practice
Fire Precautions
IEE Wiring Regulations
Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT use the appliance outside.
• DO NOT use this appliance to store medical supplies.
• DO NOT use electrical appliances inside this product (e.g. heaters, ice-cream makers etc.)
• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
• DO NOT place more than 30kg load on each shelf.
• Bottles which contain a high percentage of alcohol must be sealed and placed vertically in the appliance.
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.
• Always switch off and disconnect the power supply to the unit before cleaning.
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an agent or a recommended qualified technician in order to avoid hazard.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. The instructions concerning persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge playing with the appliance are not required.

WARNING:
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means t accelerate the defrosting process, other than those recommended by the manufacturer. Do not damage the appliance circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

Introduction

Please take a few moments to carefully read through this manual, correct maintenance and operation of this machine will provide the best possible performance from your product.

Pack Contents

The following is included:

• Refrigerator or Freezer
• Shelves x 4 or 5 (Single door)
• Keys x 2
• Instruction manual

We pride ourselves on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as result of transit, please contact your dealer immediately.

Installation

Note: if the appliance has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow the appliance to stand.

1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings ate thoroughly removed from all surfaces.

2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation. Increase this distance id the obstacle is a heat source.
   Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

3. Set the brakes on the castors to keep the appliance in position OR level the appliance by adjusting the screw feet.

Lock/Unlock the Doors
A lock is fitted to the doors to ensure foodstuffs are kept secure within your appliance.
Use the keys provided to lock/unlock the door ALL COMPACT models are equipped with a door lock, ensuring that stocks are safe after closing.
Refrigerant
The R600a and R290 refrigerant used by this appliance.

Fitting the Shelves

• Place one set of shelf guides on either side of the cabinet at the desired height.
• Slide the shelf into place.
• Repeat for the remaining shelves.
• The shelf supports up to 30kg.
• The number of shelves depend on how many you want

Note: this is vital for ensuring correct drainage of condensation

Operation Storing Food

To get the best results from your appliance, follow these instructions:

• Only store foodstuffs in the appliance when it had reached the correct operating temperature.
• Do not place uncovered hot food or liquid inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans where possible
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods of time.
• Foodstuffs should be 30cm away from the back of the appliance.
• Do not place constituents of foods (e.g. acid, alkali or salt) inside the appliance.

Turn on

• Close the door(s) of the appliance.
• Turn on at the socket.
• Switch on the Power. the current temperature within the appliance is displayed.

Cleaning, Care & Maintenance

• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance, sharp edges can cut.
• An agent or qualified technician must carry out repairs if required.
• Cleaning the Condenser
• Periodically cleaning the condenser can extend the life of the appliance. We recommend that out agent or qualified technician clean the condenser.

Disposal
EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components. Consult your local waste collection authority regrading disposal of your appliance. Local authorities are obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Compliance
Parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
Products have been approved to carry the following symbol:
Disposal of packaging
All packaging materials should be disposed of in an environmentally friendly way.
The cardboard may be used as scrap paper.
The protective foil and the foam cushions are CFC-free.
Do not allow children to play with the packaging and destroy plastic bags safely.
You can break or cut the cardboard into smaller pieces and give to a waste. Environment protection Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively support us in conserving resources and protecting the environment by returning this appliance to the collection centers (if available).
**** IN CASE THE SUPPLY CABLE IS DAMAGED, THE MANUFACTURER OR THE AFTERSALES SERVICE, OR QUALIFIED TECHNICIAN SHALL REPLACE IT, IN ORDER TO PREVENT ANY POSSIBLE RISK.
THE LAMP REPAIR AND REPLACEMENT SHALL BE CARRIED OUT BY QUALIFIED TECHNICIANS, WITH POWER SUPPLY DISCONNECTED. REPLACE WITH IDENTICAL LAMPS.
ONLY QUALIFIED TECHNICIANS SHALL CARRY OUT THE EXTRAORDINARY MAINTENANCE INTERVENTIONS.

Troubleshooting

If your appliance develops a fault, please check the following table before making a call to your retailer.

plugged in correctly and switched on
Plug and lead are damaged| Call your agent or qualified Technician
Fuse in the plug has blown| Replace the fuse
Power supply| Check power supply
Internal wiring fault| Call your agent or qualified Technician
The appliance turns on, but the temperature is too high/low| Too much ice on the evaporator| Defrost the appliance
 Condenser blocked with dust| Call your agent or qualified Technician
Doors are not shut properly| Check doors are shut and seals are not damaged
Appliance is located near a heat source or air flow to the condenser is being interrupted| Move the appliance to a more suitable location
Ambient temperature is too high| Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance| Remove ant excessive hot foodstuff or blockages to the fan
Appliance is overloaded| Reduce the amount of food stored in the appliance
The appliance is leaking water| The appliance is not properly levelled| Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked| Clear the discharge outlet
Movement of water to drain is obstructed| Clear the floor of the appliance (if applicable)
The water container is damaged| Call your agent or qualified Technician
The drip tray is overflowing| Empty the drip tray (if applicable)
The appliance is unusually loud| Loose nut/screw| Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position| Check installation position and change is necessary

Access to professional repair, such as internet webpages, addresses, contact details.
Model no: GUR390W
Aftersales service station list:

Address| Linåvej 20 . 8600 Silkeborg . Denmark| QR codehttps://eprel.ec.europa.eu/qr/1557673
---|---|---
Contact Number| 0045 7242 5571
Website| www.scandomestic.dk
Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer or authorised representative;| www.scandomestic.dk
The minimum period during which spare parts, necessary for the repair of the appliance, are available; (years)| 8
defined in Regulation  by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.)| www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

Access to professional repair, such as internet webpages, addresses, contact details.
Model no: GUF390W
Aftersales service station list:

Address| Linåvej 20 . 8600 Silkeborg . Denmark| QR code https://eprel.ec.europa.eu/qr/1557616
---|---|---
Contact Number| 0045 7242 5571
Website| www.scandomestic.dk
Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer or authorised representative;| www.scandomestic.dk
The minimum period during which spare parts, necessary for the repair of the appliance, are available; (years)| 8
defined in Regulation  by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.)| www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

EU declaration of conformity

Name and address of the manufacturer or his authorise
Scandomestic A/S
Linåvej 20
8600 Silkeborg
Denmark
This declaration of conformity is issued under the sole responsibility of the manufacturer (or installer):
Scandomestic A/S
Linåvej 20
8600 Silkeborg
Denmark
References to the relevant harmonised standards used, or references to the specifications in relation to which conformity is declared:
EN ISO 17050-1: 2004
Additional Information
…………………………..
Object of the declaration
(identification of product allowing traceability. It may include a colour image of sufficient clarity to enable the identification of the product)

The object of the declaration described above is in conformity with the relevant Union harmonisation legislation:
REACH 1907/2006, RoHS 2011/65/EU, ISO 14001, ISO 9001, LVD 2014/35/EU
EMC 2014/30/EU, ErP EU No 2019/2016, ErPEU No 2019/2019, IEC60335
2 24:2010+A1:2012+A2:2017, IEC60335, 1:2010+A1:2013+A2:2016, EN60335
2 24:2010+A1:2019+A2:2019, EN60335, 1:2012+A11:2014+A13:2017, EN62233:2008

EU declaration of conformity
Name and address of the manufacturer or his authorise
Scandomestic A/S
Linåvej 20
8600 Silkeborg
Denmark
This declaration of conformity is issued under the sole responsibility of the manufacturer (or installer):
Scandomestic A/S
Linåvej 20
8600 Silkeborg
Denmark
References to the relevant harmonised standards used, or references to the specifications in relation to which conformity is declared:
EN ISO 17050-1: 2004
Additional Information
………………………………….
Object of the declaration
(identification of product allowing traceability. It may include a colour image of sufficient clarity to enable the identification of the product)

The object of the declaration described above is in conformity with the relevant Union harmonisation legislation:
REACH 1907/2006, RoHS 2011/65/EU, ISO 14001, ISO 9001, LVD 2014/35/EU
EMC 2014/30/EU, ErP EU No 2019/2016, ErPEU No 2019/2019, IEC60335
2 24:2010+A1:2012+A2:2017, IEC60335, 1:2010+A1:2013+A2:2016, EN60335
2 24:2010+A1:2019+A2:2019, EN60335, 1:2012+A11:2014+A13:2017, EN62233:2008

Scandomestic A/S . Linåvej 20
DK-8600 Silkeborg
Denmark. CVR .No.: 29774242
Tel.: +45 7242 5571
www.scandomestic.dk
info@scandomestic.dk

Documents / Resources

| scandomestic GUR 390 Freezer [pdf] User Manual
GUR 390, GUF 390, GUR 390 Freezer, GUR 390, Freezer
---|---

References

• Scandomestic | scandomestic.dk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>