TRIXIE 24464 Bubble Stream Instruction Manual

TRIXIE 24464 Bubble Stream

Product Information

Specifications

• Product Name: Bubble Stream
• Power: 12V
• Capacity: Up to 3 liters of water

Product Usage Instructions

1. Read the instructions carefully before operating the device.
2. First Use:
3. Fill the water container with up to 3 liters of fresh water.
4. Place the white top on the container, ensuring that the end of the funnel on the back of the top connects to the water outlet of the pump.
5. Connect the pump cable to the mains plug.
6. Place the water container on a level surface.
7. Plug in the device to turn on the automatic water dispenser.
8. Acquainting your pet with Bubble Stream:
   • To help easily scared pets get used to the Bubble Stream, place a few treats on the rim of the water dispenser. This will help them associate the water dispenser with a positive experience.
9. General Instructions for Use:
   • Dispose of waste properly. Hand it in at a disposal facility for this type of device.
10. Cleaning and Maintenance:
    • Cleaning:
    • Unplug the device before cleaning.
    • Loosen the top and, if necessary, remove the water filter and pump.
    • Wipe all parts with a damp cloth.
    • Except for the plug, pump, and water filter, all other parts are dishwasher-safe.
    • To prevent limescale formation, clean the pump with a standard descaling agent.
    • Exchanging the pump:
    • If the water pump is broken, unplug the device and remove the white top of the automatic water dispenser.
    • Loosen the three screws on the underside of the dispenser and remove the white stand.
    • Unlock the cable holder underneath the automatic water dispenser and then remove the water pump.
    • Follow these steps in reverse order to install a new pump (matching replacement item: 24464-31).

Frequently Asked Questions (FAQ)

• Q: Can I use any descaling agent to clean the pump?
  A: Yes, you can clean the pump with a standard descaling agent to prevent limescale formation.

• Q: How much water can the Bubble Stream hold?
  A: The Bubble Stream can hold up to 3 liters of water.

• Q: Are all parts of the automatic water dispenser dishwasher safe?
  A: Yes, except for the plug, pump, and water filter, all other parts are dishwasher-safe.

• Q: How do I replace the water pump?
  A: To replace the water pump, unplug the device, remove the white top of the automatic water dispenser, loosen the screws on the underside, remove the white stand, unlock the cable holder, and then remove the water pump. Follow these steps in reverse order to install a new pump.

Introduction

• Please read the following instructions carefully before operating the device. Keep the instructions for further reference.
• The refreshing fountain for your pet. A lot of cats and dogs prefer running drinking water as it seems similar to natural springs like creeks and ponds.Some pets even avoid a simple water bowl, which can lead to an insufficient water intake.
• The Bubble Stream is an ideal solution. It provides your pet with running water and motivates your pet to drink. The running water ensures optimal oxygenation of the water and natural cooling. The integrated activated carbon filter cleans the water and provides a better taste.

First Use

1. First of all, remove the white top of the automatic water dispenser. To do this, turn the rim of the top slightly to the outside all around the top until you can hear several locking points clicking open. Lift the top to reach the water pump. The water pump is attached to the bottom of the water container with two suction cups and is easy to remove if needed. On the side of the pump, there is a slide switch to regulate the output of the pump. When inserting the pump again, make sure that the water outlet is exactly in the center of the water container.
2. Now fill the water container with up to 3 l of fresh water and then place the white top on the container. Make sure that the end of the funnel on the back of the top connects to the water outlet of the pump.
3. Now connect the pump cable to the mains plug and place the water container on a level surface. Plug in the device to turn the automatic water dispenser on.

Changing the water filter

Acquainting your pet with Bubble Stream

To acquaint easily scared pets with the Bubble Stream, you could e. g. place a few treats on the rim of the water dispenser. That helps your pet to link the water dispenser to a positive experience.

General Instructions for Use

• The pump should always be completely covered in water. Do not run the pump without water. If you can hear the pump sucking in air and it is louder than usual, the water level is too low. Fill in more water immediately.
• For refilling, you can pour water into the automatic water dispenser carefully from the top. An alternative is to remove the top and fill the water directly into the water container.
• Please ensure that the water level stays below the filter. Otherwise, the water cannot drain away correctly and there is the danger of the water overflowing.
• In cases of hard water, we recommend using still mineral water instead of tap water. Using hard tap water makes frequent cleaning of the pump necessary to prevent limescale formation.
• Disconnect the water dispenser from the main socket before you carry out any maintenance work. To disconnect the device, do not pull on the cable, but rather pull on the plug.
• Do not run Bubble Stream if the cable or plug is damaged, after a malfunction, or after it has been dropped or damaged in any other way.
• Do not touch any moving parts of the pump.
• Do not use the device outdoors.
• Please note that the product should not be disposed of with household waste. Hand it in at a disposal facility for this type of device.

Cleaning and Maintenance

Cleaning:
It is easy to disassemble the automatic water dispenser into its parts for cleaning. First, unplug the device, then loosen the top and if necessary remove the water filter and pump as described below. All parts can be wiped with a damp cloth. Except for the plug, the pump, and the water filter, all other parts are dishwasher safe. To prevent limescale forming, the pump can be cleaned with a standard descaling agent.

Changing the water filter:
Depending on the frequency of use, the water filter should be changed approximately every 3 months. If the automatic water dispenser is used by several animals, it should be changed at shorter intervals. First, unplug the device to turn the automatic water dispenser off. Remove the white top to have access to the water filter. The filter is on the back of the top and can be removed by lightly pulling on the blue flaps of the filter case. Then insert a new filter (matching replacement item: 24465).

Exchanging the pump:
Should the water pump be broken, it is easy to remove it and replace it with a new pump. Unplug the device and remove the white top of the automatic water dispenser. Loosen the three screws on the underside of the dispenser and remove the white stand. Unlock the cable holder underneath the automatic water dispenser and then remove the water pump. Follow these steps in reverse order to install a new pump (matching replacement item: 24464-31).

Cleaning the Pump

In continuous use, the pump needs to be cleaned every 3-4 weeks to prevent wear.

Please note:
Unplug the drinking fountain before each maintenance. Do not touch any moving parts.

Proceed as follows:

1. Remove the cover of the pump and pull the rotor out of the plug-in connection.
2. Clean all parts with a small brush or a Q-tip, then rinse the parts in clear water. Do not use any detergent for cleaning.
3. Finally, plug the rotor back on the pump casing carefully and place the cover on top.

Contact Information

TRIXIE Heimtierbedarf · Industriestr. 32 · 24963 Tarp · GERMANY · www.trixie.de.

References

• TRIXIE Heimtierbedarf - Your wholesale for pet supplies, snacks and more

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>