medela Freestyle Hands Free Breast Pump User Guide
- June 15, 2024
- medela
Table of Contents
medela Freestyle Hands Free Breast Pump
Product Information
Specifications:
- Model: [Model Name]
- Brand: [Brand Name]
- Power Supply: [Power Supply Type]
- Timer: Yes
- Vacuum Modes: Constant Vacuum, Sucking Cycles
- Battery Display: Yes
Product Usage Instructions
Troubleshooting Steps
In case of any unexpected behavior with your breast pump, please
refer to the troubleshooting table below:
| Problem | Solution |
|---|
The breast pump does not enter the standby mode after you
pressed the On/Off button| You may have pressed the On/Off button for too
short or too
long a time. Press the On/Off button until you hear an audio
signal, then release it. If the pump is in storage mode, it may
take slightly longer until the audio signal is emitted.
The display does not light up after you pressed the On/Off
button| To reset your breast pump, press and hold the On/Off button (on
the side) for seven to ten seconds. If there is no change, ensure
that the breast pump is connected to a properly working power
supply. If the issue persists, please contact Medela Customer
Service.
The timer does not count up after you pressed the Start/Pause
button| Please contact Medela Customer Service for assistance.
The breast pump generates no vacuum (motor not working) after
you pressed the Start/Pause button| First, ensure that the breast pump is
switched on. If the issue
persists, please contact Medela Customer Service for further
assistance.
The breast pump generates only constant vacuum instead of
sucking cycles| Please contact Medela Customer Service for assistance.
The breast pump stops operation or cannot be turned on (emits
an audio signal and all elements of the battery display are
flashing)| The breast pump may refuse operation due to battery
over-temperature. Allow the motor unit to cool down and then
restart the breast pump.
The breast pump does not enter the standby mode after you pressed the On/Off button
You pressed the On/Off button for too short or too long a time. Press the On/Off button until you hear an audio signal, then release it. If the pump is in storage mode, it will take somewhat longer (approx. one second) until the audio signal is emitted.
The display does not light up after you pressed the On/Off button
To reset your breast pump, press and hold the On/Off button (on the side) for seven to ten seconds. If there is no change, make sure that the breast pump is connected to a properly working power supply. If there is still no change, contact the Medela Customer Service.
The timer does not count up after you pressed the Start/ Pause button
Contact the Medela Customer Service.
The breast pump generates no vacuum (motor not working) after you pressed the Start/Pause button
Make sure that the breast pump is switched on. Contact the Medela Customer Service.
The breast pump generates only constant vacuum instead of sucking cycles
Contact the Medela Customer Service
The breast pump stops operation or cannot be turned on (emits an audio signal and all elements of the battery display are flashing)
The breast pump refuses operation due to battery over-temperature. Allow the motor unit to cool down, then restart the breast pump.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>