ACEMINING 8801 Square Heavy Duty Door Handle Lever Set Instruction Manual
- June 15, 2024
- ACEMINING
Table of Contents
ACEMINING 8801 Square Heavy Duty Door Handle Lever Set
Detailed components
Tools needed
Determining door handling
Door handling is determined by standing outside the place/room and looking where the hinges are placed. If they are placed on the right side the door is right and left if the hinges are placed on the left side.
Door preparations
HOLE MARKING
Place the template and fold on the door edge, check the distances and centers
to drill. Select the distance from the edge of the door. It is recommended to
install 90 to 100cm regarding of floor.
HOLES
Carefully punch the door with a drill on the previously marked centers, doing
first the larger diameter to 54mm (2 1/8″) and then the center of the edge of
the door of 24mm(15/16″).
Latch preparation
Insert the bolt into the hole 24 mm and draw the outline of the front, slot with the chlsel all this area to 3 mm depth of where the latch, plate will lodge
Setting latch
Adjust the latch to the distance you are going to install, 60 or 70 mm (Backset 2 3/8″ or 2 3/4″).
Latch installation
Insert the latch into the hole in the door edge with its sloping side according to the direction that go to close the door. Screw it on the door edge until the plate flush with the surface.
Fixing of exterior handle lock
Install the lock of exterior handle by inserting the posts and the square bolt into the holes on the latch mechanism.
Installation of interior handle lock
Install the interior handle lock connecting it to the square bolt of the outer
part and positioning the screws from the interior latch toward the posts.
Screw and try the operation.
Strike installation
Install the strike in the frame of door using the height of the latch to do the needed perforations.
Template
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>