SMUG C-1368-5B Drafting Chair Tall Office Chair Instruction Manual

SMUG C-1368-5B Drafting Chair Tall Office Chair

Package List

• Without further ado, we kindly suggest you to list all parts needed for the chair first.

Assembly Instruction

• Step 1: Turn the Base (6) upside down, then insert Base Legs (7) one by one to Base.
  • Use the Wrench (14) to screw Ten Bolts (9) into the pre-drilled screw holes to fix the Base and the Base Legs.
• Step 2: Both hands are forced at the same time to press the Casters (8) into the holes at the end of each Base Leg.
• Step 3: Insert the lower end of the Gas Lift (5) into the center hole of the Foot Ring (13) and lift the Foot Ring (13) up to fix it on the Gas Lift (5). Then insert the Gas Lift (5) into the hole in the center of the base. Remove the cover from the top of the Gas Lift (5).
• Step 4: Attach the Armrest (3)1(R) to th e Backrest (1). Pay attention to the Backrest slot. Use the Wrench(13) to fix bolt(11)2 into the position B1and B2.
  • All bolts do not need to be tightened, they only need to be fixed in half.
• Step 5: Attach the Armrest (3)1(L) to the Backrest (1) . Pay attention to the Backrest slot. Use the Wrench(13) to fix bolt (11)2 into the position B1and B2.
  • All bolts do not need to be tightened, they only need to be fixed in half.
• Step 6: Turn the Seat Cushion (2) upside down and align the hole position of the Armrest (3)1(L)1(R) with the pre-drilled hole position under the Seat Cushion. Attach the Armrest (3)1(L)1(R) to the Seat Cushion (2) with Six Bolts (12).Using the Wrench (14). 100% tighten the Bolts.
  • Note 1: The “Front” mark on the Armrests and the “Front” mark on the Seat Cushion should be in the same direction.
  • Note 2: Armrests are labeled with an “L” (left) or “R” (right) to show which side they should be placed on.
• Step 7: Attach the Mechanism (4) to the Seat Cushion using Two Bolts (10) at the front and Two Bolts (10) at the back, tighten all the bolts with the Wrench (14).
• Step 8: Insert the slot on the back of the mechanism behind the cushion into the Gas Lift.
• Step 9: 100% tighten the Backrest Armrest Bolts

CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 month or whenever needed.

Instructions For Use

Seat Height: Paddle-shaped lever on the right side

• At the proper height, your feet should rest flat on the floor.

Padded Flip-up Arms

• The padded feature allows you to rest comfortably.
• The armrests of the office chair have a flip up design, you could customize them according to your needs.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>