PGK 4P WP Enclosures IP66 SE008A Installation Guide
- June 3, 2024
- PGK
Table of Contents
Proudly Australian owned
PGK 4P WP Enclosures IP66
SE008A
PGK 4 Pole DIN Rail Mounting Waterproof Enclosure
Installation
Guide
Technical Specifications
Type| SE008A
Protection class| IP65 (IEC60529)
Installation place| Outdoor/ Indoor
Color| Grey
Material| Polycarbonate
UV Resistance| Yes
Gland entries| 4pcs x M25
Fixing screws| 6pcs
Padlockable| Yes
DIN Rail mounting| Yes
Caps for base hole| 4pcs
Caps for top screw| 4pcs
Measurement (LxWxH)| 205*99.5110mm
Earth terminal| /
Neutral terminal| /
Impact resistance| 70kJ/m2
Vertical
- Use internal mounting screw caps to maintain IP rating in base.
- Ensure all screws of cover are tight to 1~1.5 N.m
- Fit caps over lid screws to maintain IP rating.
- No restrictions in mounting.
Horizontal
- Use internal mounting screw caps to maintain IP rating in base.
- Ensure all screws of cover are tight to 1~1.5 N.m
- Fit caps over lid screws to maintain IP rating.
- Ensure angle > 5o from vertical and horizontal so water can not pool against gasket.
- Use SE008A to mount enclosures under panels.
Please Note:
Please consult with your Electrician/Engineer to ensure suitability for the
intended application and installation.
PGK Distribution takes every precaution to ensure the information in this
plublication is correct but accepts no liability of any kind and reserves the
right to change any detail in this catalogue without notification.
PGK Distribution
VIC Main Office
8 Mohr St Tullamarine, Vic 3043
T: 1300 PGK SOL
www.pgkdistribution.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>