PRINTEK I-820 Interceptor Series Portable Printers User Guide
- June 15, 2024
- PRINTEK
Table of Contents
PRINTEK I-820 Interceptor Series Portable Printers
This guide provides information on the daily use of the I-820 printer. For additional information, please refer to the I-820 User Guide. BEFORE you begin, please visit www.printek.com Support; Downloads; Drivers and Software, to download the I820 printer driver.
Printer features
PRINTEK I-820 Interceptor Series Portable Printers
Media (8.5’’)
Press Paper door release button to open the paper compartment door. Pull small leader of paper out and close paper door. “Clicks” when properly closed.
Printer with optional battery: Charging
- New batteries are shipped in uncharged state.
- Charge using Printek approved external AC or DC adapter.
- DO NOT charge battery via USB port.
- Charge for minimum of four hours prior to use.
Approximate battery life of 100 pages.
Printer with optional battery: Replacement
Battery Disposal
Only dispose of used batteries according to your local regulations. If you do not know your local regulations, the Rechargeable Battery Recycling Corporation (RBRC) is a non-profit organization created to promote recycling of rechargeable batteries. For more information visit www.call2recycle.org
Control Panel indicators
Control Panel
Power Button| Power Up Power Down
Toggle IP over USB
on/off
| Press & Release Press & Hold Press twice
Paper Feed Button| Advance paper Print Setup Report| Press once (LF) or
long (FF) Press twice
Power & Status
(Green/Red)
| Battery
(Yellow)
| Alert
(Red)
| Indication
On| Off| On| Booting up(… 20 sec!)
On| Off| Off| Ready
On| Off| Flashing| Paper Error/Lid Open
Flashing| Off| Off| Job is arriving
Flashing| Off| Off| Job is printing
Flashing| Off| Flashing| IP over USB active
| On| | Charging Battery
| Flashing| | Battery Low
Flashing| Flashing| Flashing| Restart the printer manually
Off| Off| Flashing| Restore the printer firmware
Off| Off| On| Print head too hot
Control Panel
Self-Test / Configuration print out
With power on, press the Paper Feed button twice quickly.
Accessing the Configuration Menus through USB
- Turn the printer ON.
- Connect a USB cable between the printer and a PC.
- To access the I-820 web page, push the Power button twice rapidly. This will put the printer into Configuration mode.
- When the printer is in Configuration mode the POWER and FAULT LEDs will flash together.
- Open browser on your PC and type 169.254.200.1 into the address bar of the browser and hit Enter – A login box should appear:
- Type “0000” and hit Enter- you should now be at the home page for I-820 Configuration.
- Push the Power button twice rapidly to exit Configuration Mode.
- On ce the printer is connected via USB and in IP over USB mode it is temporarily not possible to access the Internet.
Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:800.368.4636 www.printek.com
References
- Call2Recycle | Leading the Charge For Battery Recycling
- PRINTEK | Mobile Printers and Dot Matrix Printers
- PRINTEK | Mobile Printers and Dot Matrix Printers
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>