SmartAVI SM-D2H-4D Advanced KVM Switch User Guide
- June 14, 2024
- SmartAVI
Table of Contents
SmartAVI SM-D2H-4D Advanced KVM Switch User Guide
SM-D2H-4D
A full Manual can be downloaded from
www.smartavi.com/SM-D2H-4D/
WHAT’S IN THE BOX
NOTICE
The information contained in this document is subject to change without notice. SMART-AVI makes no war-ranty of any kind with regard to this material, includ-ing but not limited to, implied warranties of merchant-ability and fitness for particular purpose. SMART-AVI will not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance or use of this materi-al. No part of this document may be photocopied, reproduced, or translated into another language with-out prior written consent from SMART-AVI, Inc.
Toll Free: (800) AVI-2123
Phone: 702-800-0005
2455 W. Cheyenne Ave, Suite 112
North Las Vegas, NV 89032
smartavi.com
TECHNICAL SPECIFICATIONS
EDID LEARN
The KVM is designed to learn a connected monitor’s EDID upon power up. In the event of connecting a new monitor to the KVM, a power re-cycle is required.
SYSTEM CONTROL
There are three ways to control the SM-DPN: Keyboard HotKeys, RS-232 Serial
Com-mands, and Front Panel Buttons.
The settings for the serial connection are as follows: Baud rate: 115200; Data
Bits: 8; Parity: None; Stop Bits: 1; Flow Control: None.
Chart Key
[CT] = Ctrl
HARDWARE INSTALLATION
- Ensure that power is turned off or disconnected from the unit and the computers.
- Use DP cables to connect the DP output ports from each computer to the corresponding DP IN ports of the unit.
- Use a USB cable (Type-A to Type-B) to connect a USB port on each computer to the respective USB ports of the unit.
- Optionally connect a stereo audio cable (3.5mm to 3.5mm) to connect the audio output of the computers to the AUDIO IN ports of the unit.
- Connect monitors to the HDMI OUT console ports of the unit using HDMI cables.
- Connect a USB keyboard and mouse in the two USB console ports.
- Optionally connect stereo speakers to the AUDIO OUT port of the unit.
- Finally, power on the KVM by connecting a 12VDC power supply to the power connector, and then turn on all the computers.
Note: You can connect up to 4 computers to the 4 port KVM.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>