Deerma F600 Ultrasonic Humidifier User Manual
- June 14, 2024
- deerma
Table of Contents
HUMIDIFIER DEM-F600
USER MANUAL
Please read this manual carefully before using the product and keep it in a safe place
PRODUCT INTRODUCTION
The fan at the bottom of the item.
PIs do not use on the blanket to avoid clogging the air inlet
- Nozzle
- Water tank
- Water gauge
- Radiator cap
- Nebulizer
- Base
- ON/OFF
- Timer
- Display
HUMIDIFIER OPERATING INSTRUCTIONS
-
Remove Nozzle cap
-
Use Tank Handle to remove Water tank.
-
Turn Water tank upside down | and remove Water tank cap
-
Fill Tank with cool water. Do not fill with warm or hot water.
-
Securely replace Tank Cap, aligning arrow to lock symbol Be sure Cap Seal is securely in place
-
Place Tank back on base
CAUTION
- Use carefully when handling Water Tank to avoid unnecessary impact. Banging or dropping the Water Tank could result in damage to the tank that will cause leaking.
- Place the humidifier on a flat, horizontal and stable surface that is not sensitive to humidity.
FUNCTION DESCRIPTIONS
Press toturnon.
Press and hold 3s to turn off.
Press , timing time can be selected from 1 hour to 12 hours, set the timer after 5 seconds, the display to restore the current ambient temperature display.
Touch followed by the file cycle operation, set the gear after 5 seconds, the
display resume display the current ambient temperature.
Press for 3s. The machine beeps 3 times and then the screen shuts down.
When the room temperature exceeds 99 °Fit’s clearly shown on the display.
Error Code E1 appearing on the screen when the water is insufficient. Please use it after add the water
-
It is recommended to clean the machine regularly, please make sure to turn off the machine power and unplug it before cleaning.
-
Humidifier’s External Cleaning: Wipe the exterior surface with a clean soft cloth with a temperature below 40°C ; Do not use hard objects when cleaning in order to avoid damaging the components; Do not use chemical detergents to clean.
-
it is advised to change the water weekly in order to keep the tank clean.
-
Storage
Make sure unit is dry.
Pack unit n original carton.
The humidifier uses ultrasonic atomizing sheet vibration to break up the liquid water into water mist. The water tank is only a transitional water storage tool. All the humidifier base sinks will have water accumulation. Please feel free to use it.
TROUBLESHOOTING
Place the humidifier at least 2 meters away from any furniture or electrical appliances to avoid damp contact.
Problem | Easy solution |
---|---|
Fi the light is not present or there’s no wind or fog | • Check that the power |
plug is securely inserted into the socket.
• Plug into another socket.
• If necessary reset the circuit breaker.
Fi the light is present but there’s no wind or fog| • Check whether the base
level is too high.
• Pour some water inside the base and tighten the lid.
Spray less| • Check whether there’s too much nebulizer or eventual water
impurities.
• Clean the nebulization film, replace with clean water.
Abnormal noise| • Check if the water tank isn’t filled with too much water or
that the surface of water is unstable.
• In case that the surface is unstable, add water in the tank and make sure
the humidifier is placed on a smooth surface.
The water can not reach the base| • Check whether the water tank cover is
eventually unclean or the water tanks not placed properly.
• Clean the water tank cover and make sure that the tank is set properly.
Leaks| • Check whether the machine is correctly leveled.
• Check whether the water tank and the base are completely corresponding.
• During the process of carrying the water tank, please do not touch the
water tank covering order
to avoid water leakage.
Product Name| Ultrasonic Humidifier
---|---
Model| DEM-F600
Water Tank Capacity| 5L
Material| ABS
Net Weight| 1.3kg
Gross Weight| 1.6kg
Packing dimensions| 210x210x330MM
Voltage| 220-240V~ 50/60Hz
Power| 25W
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>