deerma DEM-TB880 Spray Mop User Guide
- June 12, 2024
- deerma
Table of Contents
DEM-TB880 Spray Mop
User Guide
Dry immediately while mopping, reducing the burden of cleaning Get rid of
heavy cleaning methods, lightweight fuselage mAh cleaning effortless without
bending over. Just tap that spray water mist to achieve a slightly wet clean.
That is, if dry without water march, quickly mAh the whole house clean and
dry.
Read Instruction manual carefully before use
Product Structure
- Water tank assembly
- Spray mop main body assembly
- Mop head
- Mop holder
- Handle assembly
- Connector
Precautions
- It is recommended to use clean water or neutral detergent in the water tank. The water pump and nozzle in the body are of precise structure. To prevent clogging, do not use highly corrosive liquids; After each use, filose third of the water tank with clean water and spray, in order to clean the pump and nozzle.
- If the pump and nozzle remained uncleaned after using a non—-neutral cleaning agent, slow trigger rebound may occur or the spray effect will be weakened. You can fill onethird of the water tank with clean water to and pull the trigger quickly and repeatedly to clean the pump and nozzle.
- For better cleaning effect, it is recommended that new pads be rinsed with clean water before the first use.
- Do not use softener to wash the pad.
Technical Specifications
Product name: spray mop
Product model: DEM-1E3880
Capacity: 280mL
Product size: 3751521246mm
Material: A13S, PET, stainless steel
Packing List
| Item | Quantity |
|---|---|
| Instructions | 1 |
| Main body | 1 |
| Pad | 1 |
Product Installation
Mop handle Instalation
-
Align the mop handle pole and the lower pole, push together the buckle and the hole, press the buckle with r hand, and slowly insert the handle pole until the buckle into the square hole. You will hear a click.
-
Then slowly slide the connector down the iron pipe so that the buckle enters the square hole of the connector.
Note: If the trigger does not rebound when you pull the trigger, it is because the mop handle is not well in place, and you need to reassemble it.
Mop body
and mop head instalation
-
Align the lower end of the mop body and the mop head connector, push together the buckle and the hole firmly until the buckle fits into the hole. Put the mop head onto the mop holder, pay attention to the direction of the buckle, and it’s done when you hear a click.
-
Tighten the cap when the water tank is filled with water or neutral detergent.
-
Fill the water tank with tap water or neutral detergent.
-
The water tank cap is tightened.
-
Insert the water tank back to the main body and push it into place.
Assembly
complete
Usage
hold the handle and then install the mop holder, pull the trigger to spray fan-shaped water mist to make the -floor slightly wet, and then push the mop forward at 0° – 90 ° to clean the mist and dust on the floor.
Guangdong Derma Technology Co., Ltd.
No.4-1 Longhair Road, Malang Village
Committee, Bei Jiao Town
Shunned District, Foshan City, Guangdong
Province, China
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>