ErGear EGESD4B Electric Standing Desk Instruction Manual

ErGear EGESD4B Electric Standing Desk

Specifications

• Height Adjustment Range
  • 28.3″-46.5″ (72-118cm)
• Power Input
  • 100V-240V
• Max. Speed
  • 20mm/s
• Operating Noise
  • <55dB
• Max. Load
  • 176 lbs / 80kg

Supplied Parts and Hardware

Step 1

Step 2

Step 3

Step 4

Step 5

Installation Instructions

Step 1: Assembling and Connecting the Desk Legs

Warning: HEAVY! You may need assistance with this step

Step 2: Attaching the Side Plates and the Transmission Rod

• Loosen the coupling nut.

• Before attaching the transmission rod, measure the heights of the two desk legs to see if they are set at the same level.
• If not, insert the transmission rod into the hole in the left leg. Turn the rod to adjust the left leg so it’s level with the right leg. Turn the rod clockwise to lower the left leg or anti- clockwise to raise it.

• Ensure the transmission rod is properly inserted into the hole in the left leg. Smoothly connect the other end of the rod to the end of the motor drive shaft on the right leg.
• Secure the transmission rod to the motor drive shaft by turning the set screw clockwise.

• Tighten the coupling nut to fine-tune transmission rod fit.

Step 3: Assembling and Attaching the Desktop

• Assemble the desktop.
• Attach the desktop to the frame.
• Attach the controller and hooks to the desktop.

Step 4: Connecting the Cables

Step 5: Installing the Cable Hole Covers

Using the Controller

• Save Current Height Setting
  • Short-press the s button, and the display will flash. Press the 1, 2, or 3 button to save the current height setting to that button.
• Select Height Setting 1
  • Press the 1 button, and the desk will move to the height that was previously set for that button.
• Select Height Setting 2
  • Press the 2 button, and the desk will move to the height that was previously set for that button.
• Select Height Setting 3
  • Press the 3 button, and the desk will move to the height that was previously set for that button.
• Raise the Desk
  • Press the button to raise the desk continuously until it reaches the highest position of 46.5″ (118cm) or the button is released.
• Lower the Desk
  • Press the button to lower the desk continuously until it reaches the lowest position of 28.3″ (72cm) or the button is released.

Settings

Error Codes

Protection Mode Error Codes

Complete Flexibility.
Total Freedom.

Thank you for choosing this product. We strive to provide you with the best quality products and service in the industry. Should you have any issues, please don’t hesitate to contact us.

Technical Support

• (US/CA): 1-800-651-9525 Mon-Fri, 8am-8pm (CST’
• (UK): 44-808-196-3875 Mon-Fri, 2pm-10pm (UTC)
• Other Info: support@ergear.com
• Website: https://ergear.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>