Aerpro APVTY15C Vehicle Specific Reverse Camera Instruction Manual
- June 14, 2024
- Aerpro
Table of Contents
Aerpro APVTY15C Vehicle Specific Reverse Camera
INSTRUCTION
-
When a factory ute tub has been removed and replaced with a flat tray onto the back you may also lose the factory reverse camera.
-
This kit allows you to add a high-quality CMOS NTSC reverse camera system back into the vehicle without cutting into wires or drilling.
-
The connector is located behind the front left (passenger) kick trim.
No need to disassemble the vehicle’s dash.- Disconnect the original 26 pin connector harness.
- Replace the existing 26 pin connector with the APVTY15C connector.
- Reconnect the original 26 pin connector to the APVTY15C patch wire connector
FEATURES
- Stealth registration plate mount reverse camera
- Plug & play vehicle-specific harness
- Connects to the OEM head unit
- Simple DIY installation
- 90° Horizontal lens angle
- CMOS image sensor
- Parking guidelines (optional)
- Mirror image (optional)
- PAL/ NTSC system (optional)
- IP67 Waterproof/ dustproof
INCLUSIONS
- Registration plate mount camera
- Vehicle-specific camera harness
- Product Manual
TECHNICAL ASSISTANCE
If you need assistance setting up or using your Aerpro product now or in the future, call Aerpro Support.
Australia
- TEL: 03 – 8587 8898
- FAX: 03 – 8587 8866
- Mon-Fri 9am – 5pm AEST
Please retain this user guide for future reference
Scan the QR code for product information
AERPRO.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>