TAKSTAR DA10 2 in 1 Bluetooth Wireless Microphone and Voice Amplifier User Manual
- June 14, 2024
- TAKSTAR
Table of Contents
DA 10 Speech Microphone
User Manual
■ Product
Dear Customer,
Thank you for purchasing TAKSTAR DA10 speech microphone.
Please read the user manual carefully before operation and keep it for
reference in future. If you have any questions or suggestions, please contact
our local dealer.
■ Features
- Combining microphone, power amplifier and speaker together, suitable for speech, publicity, karaoke
- Rare earth material speaker, light weight, excellent sound, high volume, peak power 8W
- One button to switch between MC mode and KTV mode, easy operation
- Wireless playing function without the trouble of cable connection, more convenient to play music
- Volume adjusting function to adjust the volume based on the venue
- Built-in DSP chip with the feedback rejecting function to reject feedback effectively
- Ultra-long standby, turning off automatically after no signal input for 15 minutes to save the power consumption
- High capacity Lithium battery for energy saving and environmental protection, approximately 8h operation time
- Compact design, comfortable to hold, suitable for reinforcement and karaoke for a long time
■ Application
Speech, publicity, karaoke, etc.
■ Product content
DA 10 speech microphone………………………………………1 pc
Windscreen………………………………………………………1pc
Type-C charging cable…………………………………………1pc
User manual………………………………………………………1 pc
■ Specification
Specification
Frequency Response: 100Hz-15kHz
Peak Power: 8W
Speaker Impedance: 4Ω
THD: THD≤5% 1KHz@4R,4W
S/N Ratio: 66dB (A-Weighted)@1W 4Ω (speech mode)
Bluetooth Version: 5.0
Reverb: Reverb
Operating Voltage: 3.4V-4.2V
Battery Type: Li-ion battery (18650)
Battery Capacity: 3.7V/2000mAh
Charging: DC5V 1.5A
Charging Time: approx. 3h
Operation Time: approx. 8h (speech)
Net Weight: approx. 220g
Dimension: Φ64mm235mm (DiaH)
Cartridge Specification
Cartridge: back electret
Polar Pattern: unidirectional
Frequency Response: 150Hz-16KHz
Sensitivity: -47.5±1.5dB(0dB=1V/Pa，at 1KHz)
Note: The data is tested by Takstar Laboratory and Takstar has the
final interpretation right!
■ Function
-
Power button: Keep pressing it for 2 seconds to turn on or off the amplifier. If it is not used for 15 minutes, it will automatically power off.
-
“M” button: Click it to cycle through 4 modes (i.e., speech mode, host mode, karaoke mode, Bluetooth mode), accompanied by corresponding voice prompt.
-
Indicator light: If it keeps lighting up green during operation, this means sufficient power supply. If the power can last for less than 1h, it keeps lighting up red. It flashes red when charged. If it keeps lighting up green, this means it is fully charged.
-
“+” button: Click it to increase the volume of the amplifier. A total of 3 levels of volume can be chosen.
-
“-” button: Click it to decrease the volume of the amplifier.
It can only be minimized to about 60% of the total volume. There is no mute function. -
Cartridge: When speaking, the mouth should be as close as possible to the pickup, generally 3-5 cm. Do not cover the cartridge with your hands; otherwise it will easily produce feedback.
-
Charging interface: Connect to the Type-C charging cable. Please use a charging head with a specification of 5V 1.5A and 3C certification to charge the amplifier.
-
Speaker: Do not put the speaker too close to people’s ears to avoid hearing damaging. Please try to keep the speaker clean.
Note: When the product is used for the first time, it is recommended to
fully charge it first; when it is fully charged, please stop charging the
battery to avoid overcharge; if it is not used for a long time, it needs to be
charged once every six months to avoid over discharge of the battery, which
will affect the battery performance.
■ Wireless pairing method
Upon first use, you need to connect to your phone or a wireless device, following below steps:
- Power up the mic and press “M” button to switch to Bluetooth mode.
- Enter SETTINGS menu on your phone, find and enable Bluetooth, wait until “TAKSTAR DA10” is discovered and tap on it to connect. If connected successfully, you should be able to play audio wirelessly through the mic.
- Next time you switch to Bluetooth mode, it will automatically pair to the previously connected device. Switching to other mode will disable wireless connection automatically.
■ Caution
In order to avoid possible personal injury or property damage caused by
electric shock, high temperature, fire, radiation, explosion, mechanical
hazards and improper use, please read and observe the following items
carefully before using the product.
- Please do not put the speaker close to people’s ears to avoid hearing damage.
- If there is any abnormality (such as smoke, odor, etc.) during use, please turn off the power switch and unplug the power plug immediately, and then send the product to the dealer for maintenance.
- The product and accessories should be placed indoors in a dry and ventilated place. Do not store them in a humid and dusty environment for a long time. Avoid getting close to fire, rain, water, excessive collision, throwing, vibrating the machine and covering the ventilation holes during use, so as not to damage its function.
- When using the product, you must abide by the relevant safety regulations. Please do not use the product in the occasions that are clearly prohibited by laws and regulations to avoid accidents.
- Please do not disassemble, refit or repair the product by yourself to prevent personal injury. If you have any questions or service needs, please contact our local dealer for follow-up.
- If you use a power adapter to supply power, you should purchase and use a power adapter that has obtained CCC certification and meets the standard requirements.
http://www.takstar.com/
Scan for more product information
Guangdong Takstar Electronic Co., Ltd.
Address: No. 2 Fu Kang YiRd., Longxi Boluo
Huizhou, Guangdong 516121 China
Tel: 86 752 6383644 Fax: 86 752 6383952
Email: sales@takstar.com
Website: www.takstar.com
CMIIT ID: 2021DP2396
Made in China