HARVEST TEC 491 110 Gallon Preservative Instruction Manual
- June 2, 2024
- HARVEST TEC
Table of Contents
HARVEST TEC 491 110 Gallon Preservative
Product Information
Specifications:
- Model: 491
- Capacity: 100 & 110 Gallon
- Installation Manual: 491-15-INST 1/23
Product Usage Instructions
Installation of Applicator:
Installation of Saddle, Legs & Mounting on Baler
Compatible Balers: Hesston, New Idea, Challenger, and Case 8570, 8575, 8580, 8585, 8590 Balers
Steps:
- Locate the parts bag and retrieve the saddle legs (001-6707C) and saddle (001-6707A).
- Install both saddle legs onto the saddle using eight 3/8 x 1-1/4 bolts, locks, and flat washers. The mounting slots in the legs should attach to the second and third weld nuts from each end of the saddle on both sides.
- Loosely attach the legs and saddle. Measure the distance from the top outside corners of the bale chamber where the saddle will be attached. Adjust the legs to match this dimension and center the saddle accordingly. Do not fully tighten the bolts until the unit is mounted on the baler.
Frequently Asked Questions (FAQ)
Q: What tools are needed for installation?
A: The following tools are required for installation:
- Standard wrench set
- Electric drill and bits
- Standard nut driver set
- Hose cutter
- Crescent wrench
- Standard screwdriver
- Standard socket set
- Center punch
- Side cutter
- Hammer
- Metal cutting tools
Harvest Tec LLC. Warranty and Liability Agreement
Harvest Tec, LLC. will repair or replace components that are found to be
defective within 12 months from the date of manufacture. Under no
circumstances does this warranty cover any components which in the opinion of
Harvest Tec, LLC. have been subjected to negligent use, misuse, alteration,
accident, or if repairs have been made with parts other than those
manufactured and obtainable from Harvest Tec, LLC. Our obligation under this
warranty is limited to repairing or replacing free of charge to the original
purchaser any part that in our judgment shows evidence of defective or
improper workmanship, provided the part is returned to Harvest Tec, LLC.
within 30 days of the failure. If it is determined that a non-Harvest Tec
branded hay preservative has been used inside the Harvest Tec applicator
system where the failure occurred, then Harvest Tec reserves the right to deny
the warranty request at their discretion. Parts must be returned through the
selling dealer and distributor, transportation charges prepaid. This warranty
shall not be interpreted to render Harvest Tec, LLC. liable for injury or
damages of any kind, direct, consequential, or contingent, to persons or
property. Furthermore, this warranty does not extend to loss of crop, losses
caused by delays or any expense prospective profits or for any other reason.
Harvest Tec, LLC. shall not be liable for any recovery greater in amount than
the cost or repair of defects in workmanship. There are no warranties, either
expressed or implied, of merchantability or fitness for particular purpose
intended or fitness for any other reason. This warranty cannot guarantee that
existing conditions beyond the control of Harvest Tec, LLC. will not affect
our ability to obtain materials or manufacture necessary replacement parts.
Harvest Tec, LLC. reserves the right to make design changes, improve design,
or change specifications, at any time without any contingent obligation to
purchasers of machines and parts previously sold. Revised 6/22
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>