ORTECH OD-A2022 LED Landscape Lighting Instruction Manual

: June 4, 2024
: Ortech

Table of Contents

WARNING
COMPONENTS
INSTALLATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Instruction Manual
LED Landscape Lighting — Deck Lights

MODEL OD-A2022

WARNING

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Read all installation instructions before installing the fixture and keep the attached instruction sheet.
This step light is intended for installation in accordance with the National Electric Code (NEC) and local code specifications.
The operating voltage range is 9V-15V AC/DC.

Application Notice

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE INSTRUCTIONS BELOW:

Keep away from combustibles. Turn OFF / unplug to change the lamp. DO NOT touch the lamp and replace it after servicing
When using multiple luminaires, the load is not to exceed the total watts of transformer rating
DO NOT operate the LED Deck Light fitted with a missing or damaged shield
Install all luminaires 10 feet (3.05m) or more from a pool, spa, or fountain
DO NOT touch the lamp directly at any time. Use a soft cloth. Oil from the skin may damage the lamp
ALWAYS use UL, cUL, and CSA recognized wire connectors for connections
DO NOT use extension cords on power units
DO NOT touch the hot lens, guard, or enclosure

CAUTION
PLEASE READ THE INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN THEM FOR FUTURE REFERENCE.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.

COMPONENTS

Please make sure the following items are included when opening the box:

ORTECH OD-A2022 LED Landscape Lighting - sambol 1

INSTALLATION

Turn off the power supply.
Open the fixture by twisting the cap counterclockwise, then pulling the cap away from the fixture. The first time it may be difficult.
Determine the desired location for each fixture, if desired, drill the wireway hole at this time. Hold the fixture in the correct direction (lead the wire through the wireway hole if necessary), and secure it with screws.
When installing on surfaces like brick or concrete walls, plastic anchors are required. Mark the location of the holes with the template in FIG.B and drill the holes for the plastic anchors with an appropriate drill bit for the material you are drilling into. Place the plastic anchors in the holes. If desired, drill the wireway hole at this time. Put fixture with a gasket at back to the location, (lead the wire through the wireway hole if necessary) and screw the 2 screws into the anchors through the holes on the fixture, securing the fixture.
Strip the 2 leads from the fixture pigtail wire. Connect the leads from the fixture to the main low voltage supply cable leads.
Put back the cap and fix it by twisting clockwise.

ORTECH OD-A2022 LED Landscape Lighting - fig 1