POWER-LITE UFO-150W Sensors LED Light Accessories Remote Instruction Manual
- June 14, 2024
- POWER-LITE
Table of Contents
POWER-LITE UFO-150W Sensors LED Light Accessories Remote
Settings
Permanent ON/OFF function
Press “ON/OFF” button, fixture goes to permanent on or permanent off mode,
sensor is disabled.
*press “Auto”, “Reset” or “Ambient learn” to quit this mode.
Dim +/-
Press “Dim” button to automatically dim up or down the light brightness
during hold time from 10% to 100%. Another press to lock it down when desired
brightness is achieved.
- After desired brightness is locked down, if user wants to dim again reversely, just press the “Dim” button again and then lock down the new brightness again.
Sensor mode
Press “Auto” button, the sensor starts to work and all settings remain the
same as the latest status before the light was switched on/off.
Reset function
Press “Reset” button, all settings go back to factory default settings.
- Factory default settings:
Sensitivity=100%
Daylight sensor=disable
Hold time=90s
Twilight Time=5min
Twilight level=10%
Ambient learn
Press “Ambient learn” button, the latest surrounding lux value overwrites
previous lux value learned, and set as the daylight threshold. This feature
enables the fixture to function well in any real application circumstance.
Test mode
“Test mode” is for testing purpose only, for users to check the
functionality and choose the desired detection range. The sensor goes to test
mode automatically after pressing this button.
Users can quit this mode by pressing “ON/OFF”, “Reset”, or any button of “Hold time”. The sensor settings are changed accordingly
- Test mode defaulted settings:
Daylight sensor=disable
Hold time=3s
Twilight time=N/A
Twilight level=N/A
In this mode, when used for on/off control, after motion detected, sensor enters into a cycle of 3s on and 2s off.
In this mode, when used for tri-level dimming control, after motion detected, sensor enters into a cycle of 3s on and 2s off (0.5s soft off + 1.5s off).
Note:
- The LED flicker indicates sensor successfully to receive RC signal artier pressing any buttons except for “Ambient learn”.
- The LED flicker TWICE to indicate sensor successfully learning ambient lux after pressing “Ambient learn”.
- When “twilight level” set at 0%, it becomes ON/OFF control.
Customer Support
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Documents / Resources
|
POWER-LITE UFO-150W Sensors LED Light Accessories
Remote
[pdf] Instruction Manual
UFO-150W Sensors LED Light Accessories Remote, UFO-150W, Sensors LED Light
Accessories Remote, Light Accessories Remote, Accessories Remote
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>