POWER-LITE CD Series 10W, 25W LED Can Downlight Installation Guide
- October 30, 2023
- POWER-LITE
Table of Contents
POWER-LITE CD Series 10W, 25W LED Can Downlight
Product Information
The Certainty at The Speed of Light 10W /25W LED CAN DOWNLIGHT is a high- quality, energy-efficient lighting solution that is perfect for both residential and commercial spaces. This downlight is available in three models: CD10W-CC-B-IP65, CD10W-CC-W-IP65, and CD25W-CC-W-IP65. It is designed to provide bright and clear illumination while consuming minimal energy.
Important Safety Instructions
Before installing and using the downlight, it is important to follow these safety instructions:
- Switch off the power supply before installation.
- Switch on the power supply only after complete installation and examination of the circuit.
- Installation and maintenance should be carried out by a professional electrician only.
Installation Procedure
Follow these steps for installing the downlight:
- Turn off the power supply.
- Select the preferred colour temperature for the downlight.
- Align the downlight with the installation surface.
- Mark the locations for drilling holes.
- Drill holes for the downlight.
- Secure the downlight to the surface using screws.
- Connect the switched live wire, earth wire, and neutral wire to the corresponding terminals in the junction box.
- Switch on the power supply and examine the circuit for proper functioning.
Dimensions
| Diameter (mm)| Height (mm)
---|---|---
10W| 90| 107
25W| 130| 115
Surface Mounted Installation
The downlight is designed for surface-mounted installation. Make sure to follow the installation procedure carefully for a safe and secure installation.
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Procedure
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
Dimensions
Surface Mounted Installation
DOWNLIGHT
- CD10W-CC-B-IP65
- CD10W-CC-W-IP65
- CD25W-CC-W-IP65
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au