POWER-LITE CD10W, CD20W LED CAN Downlight Installation Guide
- October 30, 2023
- POWER-LITE
Table of Contents
POWER-LITE CD10W, CD20W LED CAN Downlight
Certainty at The Speed of Light
The LED CAN DOWN LIGHT is a high-quality luminaire that provides efficient and reliable lighting. It is available in two models – CD10W and CD20W. The luminaire is designed to be installed in ceilings and is suitable for a wide range of applications.
Important Safety Instructions
Before installing the LED CAN DOWN LIGHT, it is important to follow these safety instructions:
- Read all instructions carefully.
- Only a licensed electrician should carry out the installation.
- Ensure that the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install the luminaire near any heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid injury or damage to the fitting, please ensure that
power leads and screws are secure before connecting the power.
Installation Procedure
Follow these steps to install the LED CAN DOWN LIGHT:
WARNING: Switch off before installation. Switch on only after complete installation and examination of the circuit. Professional electrician for installation and maintenance only.
- Turn off the power supply before starting any installation. Read instructions and check you have all the tools and accessories to complete the installation correctly.
- Loosen the screws on surface mounted frame and take out the lamp and accessory pack.
- Knock the anchor into the ceiling according to the hole distance.
- Fix the frame by screws.
- Fix the LNG into the terminal block.
- Screw back the lamp to the frame according to step 2, adjust the lighting direction.
Warning: Production modification and improper installation are not valid for warranty.
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Procedure
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly.
Can Downlight with internal driver
- STEP 1: Take out the lamp and accessory pack.
- STEP 2: Loosen the screws on surface mounted frame.
- STEP 3: Knock the anchor into the ceiling according to the hole distance.
- STEP 4: Fix the frame by screws.
-
- STEP 5: Fix the “L””N””G”into the terminal block.
- STEP 6: Screw back the lamp to the frame according to step 2, adjust the lighting direction.
Warning: Production modification and improper installation are not valid for warranty.
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au