POWER-LITE ID8W-WF LED Wifi Downlight Installation Guide
- October 30, 2023
- POWER-LITE
Table of Contents
Certainty at The Speed of Light
INSTALLATION MANUAL LED WIFI
DOWNLIGHT
ID8W-WF
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- IP54 for indoor use only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
Installation Instructions
The fitting has an insulating ceiling type IC-4 rating. Building material and thermal insulation that can safely be exposed continuously to temperatures up to 90 ℃ may abut and cover the luminaire. If the building material cannot meet this condition, the inimum clearance of 25mm is required.
See Figure 1：Installation Spacing
Tab 1: Ceiling cutout reference table. Tab 1: Ceiling cutout reference table.
| Downlight dia (inch) | 2.5 | 3 | 4 | 6 | 8 |
|---|---|---|---|---|---|
| Ceiling Cutout (mm) | 70-75 | 90 | 120 | 160 | 190 |
NOTE: Before installation, please check the IP label on the luminaire to choose the right place to install.
| IP20/IP40 | Indoor use only, do not use in wet or damp place. |
|---|---|
| IP44/IP54 | Suitable for indoor areas including bathrooms and covered/sheltered |
areas such as porches.
IP65| Suitable for outdoor areas, not suitable for water immersion.
NOTE: Before installation, please check the information of driver as below.
| Non-dim | Can not be used with any dimmer. |
|---|---|
| Triac dim | Compliable with recommended TRIAC dimmers, dimming range 8-100%. |
Installation Procedure
W ARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
- Risk of overheating of fire if the clearance distances are compromised.
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly.
Downlight with internal driver
Please select the colour temperature before installation:
WW: 3000K
NW: 4000K
CW: 5700K
- Cut a hole according to the cutout size of led downlight.
- Use screw-driver to open the driver terminal cover on the back of downlight, feed the main AC wire L. N. in terminal block respectively, then fix the cover back.
- Hold back the spring clip then push the downlight into the hole.
- Make sure the downlight fixed tightly in ceiling, turn on the power (Fig 1).
RISK OF FIRE – Required clearance from structural members and building
elements
SCB=25mm
HCB=25mm
Warning:
Input wire diameter ≥0.75mm²
Product modification and improper installation void the warranty!
https://drive.google.com/file/d/1Y-0_N77XmPktelO8KX7axtnUMNRIB121/view
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Documents / Resources
|
POWER-LITE ID8W-WF LED Wifi
Downlight
[pdf] Installation Guide
ID8W-WF LED Wifi Downlight, ID8W-WF, LED Wifi Downlight, Wifi Downlight,
Downlight
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>