POWER-LITE E-B20W-CC LED Batten Instruction Manual
- June 15, 2024
- POWER-LITE
Table of Contents
POWER-LITE E-B20W-CC LED Batten
Important Safety Instructions
To ensure correct function and safety, please read and follow all instructions carefully before using the product:
- Turn off power before installation or before doing any maintenance work.
- Do not install any luminaire near the heat source.
- For Indoor use only. Do not install this luminaires in damp or wet locations.
- Do not exceed the nominal supply voltage or amperage ratings.
- Dimmable version could be compatible with a wide range of recommended TRIAC dimmers.
- All wiring and installation of the light fitting must adhere to local and national wiring rules.
- Take care not to pull any electrical wires during unpacking as this may damage the connection.
- Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
- To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
- Please keep instructions for future reference.
Installation Procedure
Turn Off power supply before starting any installation. Read instructions & check you have all the tools & accessories to complete the installation correctly.
Step 1
Press the snap-on button and remove the cover.
Step 2
Wiring diagram only for Non-emergency function light
Knock plastic anchor into ceiling. Connect the cable to terminal block. Fix the base to the ceiling.
Step 3
Slide the preferred CCT, connect the DC plug. Press the snap-on button and fix the cover to the base.
Step 4
Installation complete.
- For non-user replaceable light sources:
“The light source contained in this luminaire shall only be replaced by the manufacturer or a similar qualified person.”
Customer Support
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>