CREATIVE EF1120 Zen Air DOT Lightweight True Wireless Sweatproof In Ear Headphones User Guide
- June 15, 2024
- Creative
Table of Contents
ZEN® AIR DOT
LIGHTWEIGHT TRUE WIRELESS SWEATPROOF
IN-EAR HEADPHONES Quick Start Guide
OVERVIEW
1. Touch Controls | 3. Charging Case LED Indicator |
---|---|
2. Earbuds LED Indicators | 4. USB-C Charging Port |
CONTROLS
BATTERY CASE CHARGING INDICATOR
To re-initiate Bluetooth Pairing, disconnect the earbuds from the connected device. The earbuds will automatically initiate Bluetooth Pairing mode after.
MASTER RESET
Manually disconnect the earbuds from your device. While the earbuds are
outside of the charging case, tap both earbuds four times, then press and hold
the earbuds for 2 seconds. Both earbuds’ LED indicators will flash white three
times, then power off. Creative Zen Air DOT will then reset to factory
default.
Master Reset is reserved for cases where users encounter issues while earbuds
are in use or during situations such as: Bluetooth Pairing failure, failure to
pair secondary earbud with the main earbud, or to reset all data.
COMMON CONNECTIVITY ISSUES
This article highlights a phenomena and recommendation for music cutting out
and earbuds that do not stay connected. When pairing a smart mobile device
with the earbuds, the signal is strongest when there is a line-of-sight
between the pairing devices.
If the signal passes through the body, which is mostly made up of water fluid,
it may get absorbed, which may result in pairing difficulty. If the mobile
device is already connected to the earbuds, it may result in signal lost or
the earbuds may get disconnected.
TECHNICAL SPECIFICATIONS
Headphone Drivers
- 13 mm Neodymium Driver x 2
Frequency Response
- 20–20,000 Hz
Microphones
- Omni-directional MEMS x 1 (Per Earbud)
Bluetooth Version
- Bluetooth 5.3
Bluetooth Profiles
- A2DP
- AVRCP
- HFP
Audio Codec
- SBC
Wireless Operating
Frequency
-
2402–2480 MHz
Wireless Operating Range -
Up to 10m / 33 ft measured in open space.
Walls and structures may affect range of device
Playtime
- Up to 7 hours per charge
- Up to 24 hours of total playtime^
Battery
- Earbuds: Lithium-ion button battery 3.7V 40 mAh 0.148 Wh
- Charging Case:
Lithium-ion polymer battery 3.7V 350 mAh 1.295 Wh
Charging Time
-
< 2 hours
IP Rating -
IPX4 (Earbuds only)
Operating Temperature -
0–45°C
Maximum RF
Output Power -
3 dBm
Input Rating -
5V 1A
^Based on moderate volume level. Actual battery life will vary with use,
settings, songs, and environmental conditions
Note: Compliance marking are located in the charging case.
PRODUCT REGISTRATION AND WARRANTY
Registering your product ensures you receive the most appropriate service and
product support available.
You can register your product at creative.com/register. Please note that your
warranty rights are not dependent on registration.
Creative warrants the included Creative-branded hardware product (the
“Product”) against defects in materials and workmanship (“Defect(s)”) for
twelve (12) months (for the European Union, twenty-four (24) months (excluding
all wear and tear), subject to certain exceptions as stated in the EU
Directive 1999/44/EC) from the date of purchase. The Creative Limited Hardware
Warranty (the “Warranty”) does not cover (but not limited to) consumable
parts, such as batteries or protective coatings that, due to their nature,
tend to diminish over time; normal wear and tear, accidents or misuse. You
must provide Creative proof of original purchase of the Product by a dated
itemized receipt to be eligible for the Warranty. If a Defect arises and a
valid claim is received during the applicable Warranty Period, Creative will
at its sole option, service the Product at no charge using new or refurbished
replacement parts at our sole discretion. Warranty benefits are in addition
to rights provided under local consumer laws.
For Australia only: Our goods come with guarantees that cannot be excluded
under the Australian Consumer Law. You are entitled to a replacement or refund
for a major failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount
to a major failure. Goods presented for repair may be replaced by refurbished
goods of the same type rather than being repaired. Refurbished parts may be
used to repair the goods. [Address: Creative Technology Ltd, 31 International
Business Park, #03-01, Singapore 609921. Telephone: +65 6895 4101 (standard
international call charges apply.)]
http://creative.com/compliance/ZenAirDOT
For the full terms and detailed information on the Warranty, please visit creative.com/compliance/ZenAirDOTor scan the QR code. A printed copy is available upon request to Creative Labs, Inc., 1900 McCarthy Boulevard, Suite 103, Milpitas, CA 95035.
REGISTER YOUR PRODUCT | TECHNICAL SUPPORT |
---|---|
creative.com/register |
© 2023 Creative Technology Ltd. All rights reserved. Creative, the Creative logo and Zen are trademarks or registered trademarks of Creative Technology Ltd in the United States and/or other countries. The Bluetooth® word mark and logo are owned by Bluetooth SIG, Inc. and any use of such marks by Creative Technology Ltd is under license. All other trademarks are the property of their respective owners and are hereby recognized as such. All specifications are subject to change without notice. Actual product may differ slightly from images shown. Use of this product is subject to a limited warranty.
References
- ccreative.com - This website is for sale! - c creative Resources and Information.
- Creative Worldwide SupportCreative Outlier Air DOT
- Creative Technology - Online Product Registration
- Creative Worldwide Support
- Creative Worldwide Support -
- Creative Labs (United States) | Sound Blaster Sound Cards, Super X-Fi, Speakers and Soundbars, Webcams, Headphones and Gaming Headsets
- Creative Technology - Declaration of Conformity
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>