Coccolle Elona Car Seat Instruction Manual
- June 15, 2024
- coccolle
Table of Contents
Coccolle Elona Car Seat
Product Information
The Coccolle Elona isize 100-150 cm car seat is an i-Size booster seat Enhanced Child Restraint System. It is approved according to UN Regulation No. 129 and is suitable for use primarily in i-Size seating positions as indicated by vehicle manufacturers in the vehicle user’s manual. The seat is designed for children between 100 and 150 cm in height, with a recommended age of 4-12 years.
The seat features adjustable headrest (a), headrest adjuster (b), shoulder belt guide (c), lap belt guide (d), base (e), reclining handle (f), ISOFIX attachments (g), ISOFIX release buttons (h), ISOFIX indicators (i), and ISOFIX vehicle anchorage (j).
Product Usage Instructions
Installation: When installing the seat in the front vehicle seat, ensure that the backrest of the vehicle seat is in an upright position.
Use Belt Only:
- If the seat cannot be used in combination with ISOFIX anchorage points in the vehicle seat, the ISOFIX attachments can be stowed inside the seat, and the seat can be used in combination with the 3-point belt only.
- Position the seat inside the vehicle. Slide the shoulder belt in the shoulder belt guide (fig.5). Make sure the belt is not twisted.
Removing the seat:
- Remove the shoulder belt out of the shoulder belt guide (fig.10).
- Squeeze the ISOFIX release button to release and pull back the ISOFIX attachments (fig.11).
- Remove the seat from the vehicle.
Safety Warnings:
- Do not use the forward-facing seat unless the child is older than 15 months.
- Ensure that the seat is installed correctly to avoid endangering your child.
Please refer to the user manual for further instructions and safety guidelines. the images shown in this instructions manual have illustrative purpose. The product purchased by you may look different.
Coccolle Elona isize 100-150 cm car seat
Instruction Manual
!! It is important that you read this user manual BEFORE installing your seat.
Incorrect installation could endanger your child.
Notice
This is a i-Size booster seat Enhanced Child Restraint System. It is approved
according to UN Regulation No. 129, for use primarily in ” i-Size seating
positions” as indicated by vehicle manufacturers in the vehicle user’s manual.
If in doubt, consult either the Enhanced Child Restraint System manufacturer
or the retailer.
Warranty conditions
- The warranty does not cover:
- Damage occurred for reasons attributable to the user.
- Damage occurred as a result of failure to use the product according to recommendations, warnings and restrictions found in the user manual and on product elements.
- Consumables subject to natural wear and tear during normal usage such as: tyres, inner tubes, tread, materials used on handles, structure and colour of fabrics and materials subject to friction, sleeves in wheels, axels, prints.
- Damage occurred as a result of failure to observe maintenance guidelines such as: corrosion, changed upholstery or plastic elements colour as a result of prolonged exposure to sunlight, damage to plastic elements of upholstery as a result of prolonged exposure to sunlight or excessive temperatures, excessive play, squeaking / creaking noises, damage to mechanism due to over-load.
- Damage occurred due to repairs being carried out by unauthorised personnel.
- Single wheels being pushed into a vertical position as a result of loading (this is normal).
- Damage and soiling occurred due to the product being incorrectly packaged for shipping (courier online purchases).
- The repair method is determined by the manufacturer/warranty service provider.
- The product subject to a complaint should be provided clean.
- The consumer goods warranty does not exclude or suspend the purchaser’s rights stemming from goods noncompliance with the agreement.
Warning
For the suitable positions in the car, read the vehicle handbook; The rigid
items and plastic parts of an Enhanced Child Restraint System shall be so
located and installed that they are not liable, during everyday use of the
vehicle, to become trapped by a movable seat or in a door of the vehicle;
“IMPORTANT – DO NOT USE FORWARD FACING BEFORE THE CHILD’S AGE EXCEEDS 15
months (Refer to instructions)”. Any straps holding the restraint to the
vehicle should be tight, that any straps restraining the child should be
adjusted to the child’s body, and that straps should not be twisted; Ensuring
that any lap strap is worn low down, and that any impact shield installed
properly, so that the pelvis is firmly engaged, shall be stressed; The device
should be replaced when it has been subject to violent stresses in an
accident;
It is a danger of making any alterations or additions to the device without
the approval of the Type Approval Authority, and a danger of not following
closely the installation instructions provided by the child restraint
manufacturer;
When the chair is not provided with a textile cover, it shall be recommended that the chair should be kept away from sunlight, otherwise it may be too hot for the child’s skin; Children should not be left in their Enhanced Child Restraint System unattended; Any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured;
The Enhanced Child Restraint System shall not be used without the cover; The Enhanced Child Restraint System cover should not be replaced with any other than the one recommended by the manufacturer, because the cover constitutes an integral part of the restraint performance.
When used for stature heights between 135 to 150cm this seat might not fit in
all vehicles;
The instructions should be retained for future use;
Components
(fig.1)
- a. Adjustable headrest
- b. Headrest adjuster
- c. Shoulder belt guide
- d. Lap belt guide
- e. Base
- f. Reclining handle
- g. ISOFIX Attachments
- h. ISOFIX release buttons
- i. ISOFIX indicators
- j. ISOFIX vehicle anchorage
Installation
When installing the seat in the front vehicle seat make sure the backrest of the vehicle seat is in an upright position.
Use ISOFIX +Belt
- Position the seat inside the vehicle. Squeeze and pull the ISOFIX release buttons to release the ISOFIX attachments. (fig.2) The ISOFIX attachments lock only in the position where it is totally extended.
- Click the ISOFIX attachments to the ISOFIX anchorage points in the vehicle seat (fig.3). Make sure that all ISOFIX indicators are GREEN. (fig.4) Push the seat as far as possible towards the backrest of the vehicle seat.
- Slide the shoulder belt in the shoulder belt guide. (fig.5) Make sure the belt is not twisted.
Use Belt Only
- If the seat cannot be used in combination with ISOFIX anchorage points in the vehicle seat, the ISOFIX attachments can be stowed inside the seat and the seat can be used in combination with the 3-point belt only.
- Position the seat inside the vehicle. Slide the shoulder belt in the shoulder belt guide. (fig.5) Make sure the belt is not twisted.
Positioning of the child
-
Adjust the headrest to the correct height by squeezing the Height adjuster.
(fig.6) The headrest must be adjusted so that there is a space two fingers wide between the headrest and your child′s shoulders. (fig.7) -
The seat can be fixed in 2 positions by sliding out the reclining Handle at the bottom of the base. Position the seat in the correct position before positioning the child with the vehicle belt. (fig.8)
-
Position the vehicle belt in front of the child and lock the belt into the buckle of the vehicle. (fig.9)
Removing the seat
- Remove the shoulder belt out of the shoulder belt guide. (fig.10)
- Squeeze the ISOFIX release button to release and pull back the ISOFIX attachments. (fig.11)
- Remove the seat from the vehicle.
Removing and refitting the cover
- Do take care when you remove the cover, as re-fitting the cover is the reverse process.
- Start to take off the backrest part first and re-fit the backrest part as the last part.
- For washing instructions, see the wash care label at the inside of the fabric cover.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>