HAVOC HFB-03-002 Steel Bender Rear Bumper Installation Guide
- June 13, 2024
- HAVOC
Table of Contents
HAVOC HFB-03-002 Steel Bender Rear Bumper
Product Information
- Product Name: Steel Bender Rear Bumper, Bronco
- Product Art # : B 03 002
Product Usage Instructions
- Remove the spare tire from the tailgate. Then, disconnect the rear sensor and tag the light wire harness from underneath the vehicle. Next, remove the bumper. Gently remove parking sensors from the bumper.
- Note : If not re-using factory parking sensors, skip to step 3.
- Align parking sensors to sensor mounts on the Rear Bumper. Stack sensor spacers and then snap the Sensor Cap.
- Gently press the sensor plug into the bumper.
- It is recommended to place painter’s tape on the lower corners of the body to avoid scratching the paint during installation. Lift and place the bumper on the frame rails. Loosely attach M12 bolt, lock washer, and flat washer to the underside of the frame rails.
- Position the stud plate inside the frame rail and loosely attach the M12 nut from the side.
- Plug parking sensors to the OE harness. Tighten all M12 hardware to a torque of 60 ft-lbs. Remove protective tape from the vehicle’s corners.
For further assistance, please contact Customer Service at 855-460-6800 or visit www.havocoffroad.com.
PARTS
INSTALLATION INSTRUCTION
-
Remove the spare tire from the tailgate. Then disconnect the rear sensor and tag light wire harness from underneath the vehicle. Next, remove the bumper. Gently remove parking sensors from the bumper.
Note: If not re-using factory parking sensors, skip to step 3. -
Align parking sensors to sensor mounts on the Rear Bumper. Stack sensor spacers and then snap the Sensor Cap.
-
Gently press the sensor plug into the bumper.
-
It is recommended to place painter’s tape on the lower corners of the body to avoid scratching the paint during installation. Lift and place the bumper on the frame rails. Loosely attach the M12 bolt, lock washer, and flat washer to the underside of the frame rails.
-
Position the stud plate inside the frame rail and loosely attach the M12 nut from the side.
-
Plug parking sensors into the OE harness. Tighten all M12 hardware to a torque of 60 ft lbs. Remove protective tape from the vehicle’s corners.
Customer Service: 855-460-6800
www.havocoffroad.com
Copyright © 2021 Havoc Offroad
ATTN: STATE OF CALIFORNIA CONSUMERS
WARNING: Cancer and Reproductive Harm –
www.P65Warnings.ca.gov.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>