HAVOC OFFROAD HFB-10-001 Tube Doors Instruction Manual

HAVOC OFFROAD HFB-10-001 Tube Doors

Components and Hardware: Front

1. Driver Tube Door, Front………………………………………………………….(1)
2. Passenger Tube Door, Front…………………………………………………..(1)
3. Driver Side Upper Bracket, Front…………………………………………….(1)
4. Driver Side Lower Bracket, Front…………………………………………….(1)
5. Passenger Side Upper Bracket, Front……………………………………..(1)
6. Passenger Side Lower Bracket, Front……………………………………..(1)
7. M8 Hex Head Bolt…………………………………………………………………(8)
8. M8 Washer …………………………………………………………………………..(8)
9. M8 Lock Washer…………………………………………………………………..(4)
10. Nut Plate………………………………………………………………………………(4)
11. Rubber Bumper…………………………………………………………………….(2)

Tools for Installation

• 13mm Socket Wrench
• 13mm Wrench

Components and Hardware: Rear

1. Driver Tube Door, Rear…………………………………………………………..(1)
2. Passenger Tube Door, Rear……………………………………………………(1)
3. Driver Side Upper Bracket, Rear……………………………………………..(1)
4. Driver Side Lower Bracket, Rear……………………………………………..(1)
5. Passenger Side Upper Bracket, Rear………………………………………(1)
6. Passenger Side Lower Bracket, Rear………………………………………(1)
7. M8 Hex Head Bolt…………………………………………………………………(8)
8. M8 Washer …………………………………………………………………………..(8)
9. M8 Lock Washer…………………………………………………………………..(4)
10. Nut Plate………………………………………………………………………………(4)
11. Rubber Bumper…………………………………………………………………….(2)

Tools for Installation

• 13mm Socket Wrench
• 13mm Wrench

Tube Doors, 2 & 4 Door

NOTE: Installation steps show Driver Side Front. Repeat this process for Passenger Side Front and Rear Set.

1. Disconnect OE wire harness. Remove door from vehicle as instructed in factory supplied user manual.
   Notice: Door removal may require assistance from another person.

2. Loosely attach upper and lower hinge using supplied M8 hardware.

3. Attach rubber bumper to inside of the tube door near the latch.

4. Using caution, slowly insert Tube Door in door hinges and reinstall factory hardware.
   Notice: Tube Door installation may require assistance from another person.

5. Close Tube Door and tighten hinge bracket hardware. Open and close door to ensure hinge brackets are properly aligned and fully seated.
   Notice: If door does not close after alignment, loosen M6 bolts securing the latch to the door. Adjust latch until door closes properly.

References

• Havoc Offroad Accessories

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>