HAVOC OFFROAD HFB-05-008 Gas Hood Struts Instruction Manual
- June 13, 2024
- HAVOC OFFROAD
Table of Contents
**HAVOC OFFROAD HFB-05-008 Gas Hood Struts Instruction Manual
**
Tools for Installation:
- 12mm Socket
- 12mm Wrench
Gas Hood Struts
-
Starting on the DRIVER SIDE. Locate and remove the bolt with a 12mm socket. Bolt will be re-used in step 2.
-
Identify Driver Side fender bracket. Ball socket will point towards engine (see image). Install the bolt removed in Step 1.
-
Tighten the bolt, making sure ball socket is towards the engine.
-
Place washer on ball socket stud and start threaded plate. Ensure that 2-3 threads are showing on back side.
This will assist in threaded plate retention.
TECH TIP: Hold the THREADED PLATE and turn the ball socket stud in hand to ensure proper rotation BEFORE installing in hood. If turned wrong way, plate will fall into hood. -
Insert threaded plate into hole.
-
Using a 12mm wrench, tighten ball stud.
-
Install strut with piston rod pointed down. Install on hood ball socket, then on fender. Repeat steps on passenger side.
HAVOC OFFROAD
SERVICE/SUPPORT: M-F 8am – 6pm EST
1-855-460-6800 | EMAIL:
support@havocoffroad.com
FOR WARRANTY INFORMATION VISIT:
www.havocoffroad.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>