Oceanic ICM-1201A Ice Maker Instruction Manual

Oceanic ICM-1201A Ice Maker

Product Information

Description:
The ICE MAKER is an electrical appliance designed for making ice cubes. It has a control panel for operation and various components such as a rear cover, top cover, water tray, evaporator, ice shovel, ice-bin-full sensor, transparent lid, ice basket, water reservoir, filter, water drain plug, compressor, power cord, and control panel.

Specifications:

• Voltage: 220-240V~
• Package Dimensions: 367 (L) x 493 (D) x 427 (H) mm

Important Notices:
When using the ICE MAKER, it is important to follow these safety precautions:

• Read all instructions before using.
• Remove all packing material and carefully check for any damages.
• Do not use the ICE MAKER outdoors.
• Do not clean the ICE MAKER with scouring powders or hard implements.
• Do not store explosive substances in the appliance.
• Fill the ICE MAKER with potable water only.
• Ensure the supply cord is not trapped or damaged when positioning the appliance.
• Avoid locating multiple portable socket-outlets or portable power supplies at the rear of the appliance.
• Keep ventilation openings clear of obstruction.
• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• Avoid damaging the refrigerant circuit.
• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

Product Usage Instructions

Operating Instructions:
Note: The water reservoir and pipeline should be well cleaned before use.

1. Step 1: Unplug the ICE MAKER and clean the water reservoir by adding water. Then, remove the plastic plug to drain out the water from the reservoir.
2. Step 2: Reinstall the plastic plug and add appropriate clean water to the reservoir.

Cleaning & Use Guidance
To clean and maintain the ICE MAKER:

1. Unplug the unit and remove the ice cubes.
2. Use a diluted solution of water and vinegar to clean the inside and outside surface of the ICE MAKER. Do not spray chemicals or diluted agents such as acids, gasoline, or oil directly on the ICE MAKER.
3. Rinse thoroughly before starting to use again.

Important Notices

When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury, including the following:

1. Read all instructions before using.

2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and that there is no damage to the ice maker or power cord and plug.

3. Before using the Ice maker for the first time, please wait 2 hours after positioning it, and keep the transparent lid open for at least 2hours

4. Pure water is not allowed to be used on this unit, spring water is recommended.

5. Ensure the voltage is compliant with the voltage range stated on the rating label, and ensure the earthing of the socket is in good condition.

6. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

7. Do not upend this product or incline it over a 45℃angle.

8. To protect against risk of electric shock, do not pour water on cord, plug and ventilation, immerse the appliance in water or any other liquid.

9. Unplug the appliance after using or before cleaning.

10. Keep the appliance 8cm from other objects to ensure the good heat releasing.

11. Do not use the accessories which are not recommended by Manufacturer.

12. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children should be supervised to ensure that they do not play with the appliance.

13. Do not use the appliance close by flames, hot plates or stoves.

14. Do not switch on the power button frequently (ensure 5min. interval at least) to avoid the damage of compressor.

15. Metal sheet or other electric objects are not allowed to be inserted into the appliance to avoid fire and short circuit.

16. Do not use outdoors.

17. Never clean with scouring powders or hard implements.

18. Please keep the instruction manual.

19. Warning: Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

20. This appliance is intended to be used in household and similar applications such as

21. staff kitchen areas in shops, offices and other working environments;

22. farm houses and by clients in hotels, motels and other residential type environments;

23. bed and breakfast type environments;

24. catering and similar non-retail applications.

25. The refrigerant and insulation blowing gas is flammable, when disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame.
    Is fire warning sign. Caution risk of fire.

26. To avoid contamination of food, please respect the following instructions:

27. Opening the lid for long periods can cause a significant increase of the temperature in the compartments of the appliance.

28. Clean regularly surfaces that can come in contact with food and accessible drainage systems.

29. WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.

30. WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

31. WARNING: fill with potable water only.

32. WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

33. WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

34. WARNING: Do not damage the refrigerant circuit.

35. WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

Specifications

• Model Number : ICM-1201
• Ice Sizes : small, large
• Ice Storage Capacity: 600 g
• Refrigerant: R600a (2 lg)
• Water Reservoir Capacity: 2.1 L
• Voltage: 220-240V~
• Frequency: 50 Hz
• Power Consumption: 120 W
• Unit Dimensions: 248(W)X372(D)X315(H)mm.
• Packing Dimensions: 367(W)X493(D)X427(H)mm

Description

1. Rear Cover
2. Top Cover
3. Water Tray
4. Evaporator
5. Ice Shovel
6. Ice-Bin-Full Sensor
7. Transparent lid
8. Ice Basket
9. Water Reservoir
10. Filter
11. Water Drain Plug
12. Compressor
13. Power Cord
14. Control panel

Control Panel Operation

• The indicator of POWER will flash after plugged in, and then the machine enters standby state. It will start to work by pressing POWER button, accompanying indicator lighting. During operation, pressing this button, the machine will return to standby state.
• This button is for selecting the size of ice. The default setting is large ice, if the small one is needed, pressing this button is available. When you select the desired size, corresponding indicator of S (small) or L (large) will be on.
• Press and hold “SELECT” button for 3 seconds to activate pipeline self-clean process, which takes “pump water in for 30 seconds—water tank run to drain out water” as a circle, and this circle will run for 5 times. Flashing of indicators of “S” and “L” will take place in turn until self-clean process is over and the machine enters standby mode. Take away the plastic plug to drain water and then whole process is finished.
• When the indicator of this button turns to red, it means insufficient water to water reservoir, you need to add enough water and press POWER button to restart the machine.
• When the ice reach to the max storage capacity, the indicator of this button will flash, and the machine will stop working. What you need to do is pouring out the ice, if the position of ice is lower than the position of ice bin full sensor, the machine will restart automatically.

Operating Instructions

Note: Water reservoir and pipeline should be well cleaned before use.

1. Step 1. Plug out, and clean the water reservoir by adding water, then take plastic plug away to drain out the water from water reservoir.

2. Step 2. Reinstall the plastic plug, and add appropriate clean water. After  connecting the power supply well, press and hold “SELECT” button for 3 seconds to activate pipeline self-clean process. After cleaning, drain out the water by taking plastic plug away.

3. Step 3. Open the lid and take out the ice basket to add appropriate water into water
   reservoir.
   Note: The water poured into water reservoir should be lower than the water reservoir’s MAX position. When water volume goes beyond the max, please open the bottom water drain plug to drain the spare water out. Then close the transparent lid.

4. Step 4. Select the desired ice size, the default size of machine is large one.

5. Note: Please select the (S) when ambient temperature is below 15°c.When
   the ambient temperature is higher than 30°C, Large ice cube sizes are recommended.

6. Note: For the first three cycles, the ice may be small and irregular in size.

7. Note: When the ice collecting tray is full please remove the ice immediately, Do not allow the ice collecting tray to overfill.

Cleaning & Use Guidance

1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may not have enough water to pump for air retard, and the indicator of “ADD WATER” will keep lighting. At this time, you just need to press POWER button again, the machine can enter normal state.
4. To ensure the cleanness of ice, please change water for water reservoir at least once one day. If do not use for a long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully water or interruption of power supply, it will delay for 3mins to start up after restarted.
6.  Always use fresh water before starting ice production either at initial installation or after a long shut-off period.

Troubleshooting

1. Please note, if a power failure occurs due to disconnection of the power cord, or the power button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket. If not, please push the ice shovel gently by finger, then press POWER button to restart.

normal.
Water shortage indicator light is on|

1. There is no water
2. The pump is full of air

|

1. Add to some water until it reaches MAX position
2. Press POWER button to restart

Indicator lights on display are not on| Blown fuse/ No power| Replace fuse / Turn power on
The Ice made is too large and with pieces sticking together.|

1. water temperature is too low
2. Ice of previous cycles left in the water tray

|

1. Select small size
2. Take out the ice under the standby state

All indicators twinkle simultaneously| Water tray is blocked by ice cube| Unplug the power to take out the ice which blocking the tray, then plug the power and press the POWER button, the machine will restart 3mins later.

WARNING

• If the power cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
• Fill with potable water only.
• It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot. Due to fast freezing, ice cubes may appear “Cloudy”. This is air trapped in the water and will not affect quality or taste of ice.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance. Do not immerse in water

1. Waring –keep ventilation openings ,in the appliance enclosure or in the built-in structure clear of obstruction.
2. Waring – do not use mechanical devices or other means to accelerate to defrosting process ,other than those recommended by the manufacturer.
3. Waring – do not damage the refrigerant circuit.
4. Waring – do not use electrical appliance inside the food storage compartments of the appliance ,unless they are of the type recommended by the manufacture.

Correct Disposal of this product

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,recycle it responsibly to promote the sustainable reuse of material resources.
You can help protect the environment! The packaging material is recyclable. Dispose of the packaging in an environmentally friendly manner and make it available for the recyclable material collection-service.

Oceanic
120-126 Quai de Bacalan CS11584 33000 Bordeaux
IMPORT FROM A.M.C.
123 quai Jules Guesde 94400 VITRY SUR SEINE
France
www.oceanic.eu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>