All American TQ-4050 Proxima Semi-Auto Dual Heat Press User Manual
- June 4, 2024
- All American
Table of Contents
TQ-4050 Proxima Semi-Auto Dual Heat Press
**User Manual
**
TQ-4050 Proxima Semi-Auto Dual Heat Press
Proxima Semi-Auto Dual Heat Press
User Manual
Installation
- Requires air hose with 5mm inner diameter & 8mm outer diameter.
- Requires air compressor with minimum 1.5kw, 50L hold tank, and 0.7M pa.
Instructions
Press the Auto/Manual switch button to change operating modes.
- Auto Mode: The heat plate presses automatically when the machine reaches the right or left ends.
- Manual Mode: Press both “Press Buttons” at the same time to heat press.
Control Panel
| Press the SET button one time to start adjusting the temperature. Press it
again to adjust the time. Press it for the third time to exit the setting
interface.
Press and hold SET button to enter the parameter setting interface. Press and
hold SET button again or power off the machine to exit parameter setting
interface.
---|---
| Press this key to decrease the corresponding parameter value after the
machine enters the parameter setting interface.
| Press this key to increase the corresponding parameter value after the
machine enters the parameter setting interface. Press and hold this key to
start self-tuning (°C or °F symbol on the panel will begin blinking). Once the
machine begins self-tuning, do not unplug or press any key until self-tuning
has finished (°C or °F symbol stops blinking). NOTE: Before applying self-
tuning, set temperature to normal working temperature and let the heat plate
cool down to room temperature. Implement self-tuning after changing the heat
plate, thermocouple wire, or control panel.
Specifications
Plate Size (in)| Voltage| Power| Dimensions (in)| Actual Weight (Ibs)|
Shipping Weight (Ibs)
---|---|---|---|---|---
15.75 x19.69| 110V| 1.8kw| 39.4(L)x26.8(W)x21.7(H)| 243.| 276.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>