Shenzhen Hailiwang Technology Co Ltd O1 Remote Auto Pet Toy Ball User Manual
- June 12, 2024
- Shenzhen Hailiwang Technology Co Ltd
Table of Contents
REMOTE AUTO PET TOY BALL 
USER MANUAL
Open ball
Turn counterclockwise to open the shell of the toy ball.
Charge
Description of LED when charging
RED:Charging
Green:Fully charged
note: lt takes about2.5 hour to fully charged.
Power&Mode
Press the power button 3sto turn on or off the power
Green LED flash:Power on
Blue LED flash:Power off
The remote
control does not need to be matched and is ready to use when you turn on ball.
Put the core into shell
Turn clockwise to close
the toy ball
Remote control
NOTE:Commands can be issued atthe dlick of a button without having to hold
it down.
WARNING: This device complies with part 15 of the FCC Rules. Operationis subject to the following two conditions:
- This device may not cause harmfulinterference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
Let your pets have fun
This pettoy ball has a built-in motion sensor, when the pet fiddles or bites
it, it will automatically start to rotate for 10 seconds, and at the same time
turn on the colorful LED light, after 10 seconds, the colorful LED light will
continue to flash for 4 seconds. Continue to attractfor 4 seconds. Continue to
attract pets to come and play with it After the first start, if not triggered,
the toy ball will start again after 120 seconds and 180 seconds, during which
it will lash colored lights at intervals to ncrease attractiveness.
When thetoy ball flashes red please charge the toy
ballin time
You can operate this toy ball through the remote control, when the petis not
actively playing with the toy ball, you can use the forward/reverse button to
wake up the toy ball toturn and glow to attract pets
Remote control battery replacement steps
Remote control
battery replacement steps:
- Use a screwdriver to unscrew the screws of the remote control shell.
- 0pen the remote control shell.
- Replace the CR2032 battery. At this time, pay attention to the polarity of the battery, that s, the positive pole is facing up, and the negative pole s facing the circuit board.
- Install the casing and tighten the screws.
NOTE: This equipment has been tested and found to comply ith the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, t hereis no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician forhelp.
Specifications
Name: Auto Pet Toy Ball
Material: Silicone+ABS
Diameter: 80mm/3.15inch
Weight: 165g/5.80z
Battery: Li-ion battery 500mAh
Charge voltage: 5V
Working mode: Crazy/Normal Mode
Waterproof: IP54
Suitable: Dogs, Cats, etc.
Packing list:
Toyball x1
Charging cable x1
User manual x1
Remote control x1
Made In China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>