ORTECH PUK 021 LED Puk Lights Instruction Manual
- June 4, 2024
- Ortech
Table of Contents
ORTECH PUK 021 LED Puk Lights
WARNING
THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
- LED Puk Lights are for INDOOR USE ONLY
- Please keep the LED Puk Lights away from any corrosive substance, and please use dry cloth when you clean it
- LED Puk Lights can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
- Before installation, cut off the power supply at the electrical panel.
CAUTION
- PLEASE READ INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN THEM FOR FUTURE REFERENCES.
- Electrical products can cause death or injury, or damage to property.
- If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
- Cut a 2-1/3″(59 mm) hole in the suitable position.
- Connect the wires on the light to the power supply, red wire to positive wire, black wire to the negative wire.
- Insert the puk light into the cut hole. Once assembly is complete, turn the power on to ensure the fixture is operating properly.
Recessed Mounting
- Diameter of hole: 2-1/3″ (59 mm)
ORTECH reserves the right to modify at any time, without notice, any or all of our product’s features, designs, components and specifications to meet market changes.
- info@ortechindustries.com
- www.ortechindustries.com
- address: 13376 Comber Way Surrey BC V3W 5V9
- 375 Admiral Blvd Mississauga, ON L5T 2N1
- Tel: 1-888-543-6473
- 1-888-541-6474
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>