RUGGED RIDGE 11549.11 Arcus Front Bumper Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 11549.11 Arcus Front Bumper
Bumper Components
- Bumper Shell (1)
- Right Fog Light Bracket (1)
- Left Fog Light Bracket (1)
- Tow Hook (2)
- Winch Tray (1)
- Winch Tray Bracket (1)
- Winch Tray Nut Plate (2)
- M12 Socket Head Bolt (8)
- M12 Washer (8)
- Nut Plate (2)
- M4 Button Head Bolt (8)
- M4 Washer (8)
- M4 Nut (8)
- M10 Washer (2)
- M10 Nut (4)
- M10 Hex Head Bolt (6)
ATT: STATE OF CALIFORNIA CONSUMERS
WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov
Tube Overrider Components
- Tube Overrider (1)
- Right Overrider Mounting Bracket (1)
- Left Overrider Mounting Bracket (1)
- M10 Washer (4)
- M10 Nut (2)
- Nut Plate (2)
- M10 Bolt (2)
Only included with part # 11549.13 and 11549.14
Assembly and Installation Instructions
-
Disconnect OE Fog Lights from vehicle and remove factory Bumper, Lower Air Dam, plastic Cover Panel, and Tow Hooks. Remove OE Fog Light Housings from factory Bumper.
-
Using supplied M4 hardware, attach Fog Light to Fog Light Bracket.
-
Using supplied M10 hardware, loosely attach Winch Tray Bracket to Winch Tray.
If installing on a 07-11 Jeep Wranglers, skip to Step 5. -
Unbolt factory vacuum pump canister.
-
Attach Winch Tray to frame horns by using supplied Winch Tray Nut Plate and M10 Hardware. Remount factory vacuum pump canister.
-
Follow Winch manufacturer’s instructions, install winch.
Make sure to tighten all Winch mounting hardware at this time. It will be difficult to access them once the bumper is fully installed.
If not installing Tube Overrider, Skip to Step 8. -
Using supplied M10 hardware and Nut Plate, attach Overrider Mounting Bracket to frame horn.
-
Position Bumper Shell and Tow Hooks into place on vehicle’s frame rails. Using supplied M12 hardware and Nut Plates, loosely attach Bumper Shell and Tow Hooks using center four holes.
-
Loosely attach Light Bracket using supplied M12 hardware.
-
Position Tube Overrider and Rubber Spacer to align with Overrider Mounting Bracket and Bumper Shell. Using supplied M10 Nut and Washer, loosely attach Overrider.
-
Attach fairlead to Bumper Shell and finish completing Winch installation.
-
Tighten all nuts and bolts.
Customer Support
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST
1-800-449-6649
FOR WARRANTY OR TECH CONCERNS EMAIL:
webmaster@omixsupport.com
460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 844-270-0593 | www.Omix- ADA.com
Copyright © 2019 Omix-Ada®, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>