RUGGED RIDGE 15102.05 Winch Cable Stopper Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
Winch Cable Stopper (Red /Black)
Installation Guide
15102.05 Winch Cable Stopper
IS-WCS-01
P/N: 15102.05 – Red
15102.06 – Black
Item List:
(1) Cable Stopper (2pcs)
(2) Allen Head Bolt
(2) Flat Washer
(2) Hex Head Nut
Caution: Cable stoppers have been designed to reduce damage caused by cable hooks making contact with winch hawse or fairlead when powering in winch cable and hook. Proper winching procedures should be followed at all times. Hands and fingers should remain clear of hawse or fairlead at all times during cable recovery. Failure to do so can result in bodily harm. Loose gloves are to be worn at all times when handling recovery cable.
Step 1: (Standard Steel Cable)
Place 2pcs cable stopper over cable just behind cable swedge.
Step 2: Insert Allen head bolts and press flat washer into cable stopper
(round opening).
Step 3: Insert hex head nut into Hex end of stopper. Using 5mm Allen head
wrench secure to cable. 
Step 1:
(Synthetic Rope – 11/32” & 3/8”)
Insert Allen head bolt into one side of stopper along with hex nut. Start
threads but do not tighten.
Step 2: Slide stopper over rope. Larger 3/8” rope will need to be placed in
the center of stopper and pressed into center opening before tightening 2nd
bolt.
Step 3: Insert remaining Allen head bolt washer, and hex head nut into
stopper. Squeeze stopper together and secure remaining bolt.Tighten bolts
making sure rope remains centered inside cable stopper. 
Step 1: (ATV Cable & Synthetic Rope)
Place 2pcs cable stopper over cable. (Stopper to slide on cable)
Step 2: Insert Allen head bolts and press flat washer into cable stopper
(round opening).
Step 3: Insert hex head nut into Hex end of stopper. Using 5mm Allen head
wrench secure to cable. 
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>