RUGGED RIDGE XHD Modular Overrider Hoop Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
XHD Modular Override Hoop, CJ, YJ, TJ & LJ
Installation Guide
XHD Modular Overrider Hoop
Components
-
Stainless Hoop………………………..(1)
-
Stainless 8mm Washer……………(8)
-
Stainless 8mm Bolt………………….(8)
-
Center Section of Modular HD Bumper should already be installed on vehicle. If hoop is replacing a different style of hoop, remove it such that you are left with empty top holes.
-
Position Hoop over the Center Section, aligning the holes in the Hoop with the holes in the top of the Center Section.
Note: The Hoop can be installed leaning back or leaning forward, depending on the desired look. Start all bolts, but do not tighten them.
-
Once all 8 bolts have been started, tighten them. Installation is now complete!
Note: Hoop is not to be used for vehicle recovery. Only the D-Rings on the front of the bumper are to be used. Hoop is not to be used for towing or vehicle recovery.
Congratulations on the purchase and installation of a quality Rugged Ridge product! Ask your retailer about the following additional accessories to the Modular HD Bumper:
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
Copyright © 2022 Omix-Ada® , Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>