TECNO ES1 Gemini E True Wireless Earbuds User Manual
- June 4, 2024
- TECNO
Table of Contents
TECNO ES1 Gemini E True Wireless Earbuds User Manual
PACKING LIST
DIAGRAM
PAIRING
Take the earbuds out of charging box, and they will automatically connect each
other, in which the LED Light fishes blue and red alternately, and then select
“TECNO Gemini E”.
Note: the earbud will automatically reconnect to the paired device by
priority. If you want to pair to another device, ‘abase firstly disconnect the
Bluetooth on your paired device.
POWER ON
Mode 1 (Auto)
**Mode 2 (Manual)
**
- The earphones automatically turn on (with blue LED light flashing) and start pairing when they are taken out from the charging case.
- In the shutdown status and when the earphones are not in the charging case, simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the We LED light flashing).
POWER OFF
Mode 1 (Auto)
Mode 2 (Manual)
- Put the earphones back in the charging case, and they’ll shut down automatically.
- If the earphones are not in the charging case, just press and hold the MFB of both earbuds for 5 seconds to power them off (Mode 2 cannot be conducted during music playing or calling)
MUSIC
INCOMING CALL
FCC Caution
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment
Email: service.us@techno-mobile.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>