KENDAL LIGHTING MSAS04-WH White Magnetic Track Instruction Manual
- June 13, 2024
- KENDAL LIGHTING
Table of Contents
WITHOUT FLANGE TRACK
TRACK CORNER INSTRUCTIONS
MSAS04 “T” CORNER
ACCESSORIES REQUIRED:
KENDAL MODEL MSAS04
WHICH INCLUDES: 3x MSAPINS
3 x MSA02 connectors
KENDAL MODEL MSA01 POWER PLATE IF REQUIRED
DIMENSIONS
STEP 1 REMOVE END CAP FROM TRACK
STEP 2 REMOVE
DECORATIVE PLATE. IF CONNECTING TO END OF TRACK THAT DOES NOT HAVE A
DECORATIVE PLATE SKIP TO STEP 5.
STEP 3 REMOVE MAGNET
STEP 4 INSERT THE MSA01 POWER PLATE(d) – SOLD SEPARATELY
STEP 5 INSTALL THE MSA22 PIN SET(b) INTO THE PIN CONNECTOR
HOLES (c) ON THE TRACK. SLIDE THE TRACK CONNECTOR (a) INTO THE SLOT ON THE
BACK OF THE TRACK SO THAT THE HOLE ON THE CONNECTOR LINES UP WITH THE SECOND
HOLE IN FROM THE END OF THE TRACK AND SECURE WITH 3 SET SCREWS(SEE INSET
PICTURE).
STEP 6 SLIDE MSAS04 TRACK CORNER ONTO
THE TRACK CONNECTOR (a) WHILE CAREFULLY LINING UP THE PIN SET WITH THE PIN SET
HOLES ON THE MSAS04 TRACK CORNER.
ATTENTION:
WHEN JOINING TRACKS OR ACCESSORIES UTILIZING PIN CONNECTORS, MAKE SURE PINS
ARE HORIZONTAL AND LINE UP WITH PIN CONNECTOR HOLES. YOU MAY NEED TO GENTLY
PUSH UP OR DOWN ON THE PINS SO THEY LINE UP CORRECTLY. FAILING TO DO THIS MAY
RESULT IN PINS MISSING THE PIN CONNECTOR HOLES AND LOSS OF THE 24 VOLT
CONNECTION. STEP 7 SECURE OTHER END OF TRACK CONNECTOR (a) TO THE TRACK
CORNER WITH REMAINING SET SCREW
STEP 8 REPEAT STEPS 1
THROUGH 7 FOR OTHER TWO SIDES OF TRACK CORNER AND COMPLETE TRACK CORNER
CONNECTION. NOTE:
AFTER EACH TRACK CONNECTION ACONTINUITY TEST SHOULD BE DONE TO ENSURE
PROPER ELECTRICAL CONNECTIONS WERE MADE.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>