KENDAL LIGHTING MSAS08-BLK Outer Corner Instruction Manual
- June 13, 2024
- KENDAL LIGHTING
Table of Contents
KENDAL LIGHTING MSAS08-BLK Outer Corner
ACCESSORIES REQUIRED
- KENDAL MODEL MSAS08
- WHICH INCLUDES: 2× MSAPINS
- 2 × MSA02 CONNECTORS
- KENDAL MODEL MSA01 POWER PLATE IF REQUIRED
DIMENSIONS
Installation Instructions
- STEP 1 REMOVE THE END CAP FROM THE TRACK
- STEP 2 REMOVE THE DECORATIVE PLATE. IF CONNECTING TO THE END OF THE TRACK THAT DOES NOT HAVE A DECORATIVE PLATE SKIP TO STEP 5.
- STEP 3 REMOVE MAGNET
- STEP 4 INSERT THE MSA01 POWER PLATE(d) – SOLD SEPARATELY
- STEP 5 INSTALL THE MSA22 PIN SET(b) INTO THE PIN CONNECTOR HOLES (c) ON THE TRACK. SLIDE THE TRACK CONNECTOR (a) INTO THE SLOT ON THE BACK OF THE TRACK APPROXIMATELY HALFWAY AND SECURE TO TRACK WITH TWO SET SCREWS.
- STEP 6 SLIDE MSAS08 TRACK CORNER ONTO THE TRACK CONNECTOR (a) WHILE CAREFULLY LINING UP THE PIN SET ON THE TRACK WITH THE PIN SET HOLES ON THE TRACK CORNER.
ATTENTION
- WHEN JOINING TRACKS OR ACCESSORIES UTILIZING PIN CONNECTORS, MAKE SURE PINS ARE HORIZONTAL AND LINE UP WITH PIN CONNECTOR HOLES. YOU MAY NEED TO GENTLY PUSH UP OR DOWN ON THE PINS SO THEY LINE UP CORRECTLY.
- FAILING TO DO THIS MAY RESULT IN PINS MISSING THE PIN CONNECTOR HOLES AND LOSS OF THE 24-VOLT CONNECTION.
- STEP 7 SECURE OTHER END OF TRACK CONNECTOR (a) TO THE TRACK CORNER WITH REMAINING TWO SET SCREWS
- STEP 8 REPEAT STEPS 1 THROUGH 7 FOR THE OTHER SIDE OF THE TRACK CORNER AND COMPLETE THE TRACK CORNER CONNECTION.
NOTE
AFTER EACH TRACK CONNECTION A CONTINUITY TEST SHOULD BE DONE TO ENSURE PROPER
ELECTRICAL CONNECTIONS WERE MADE.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>