KENDAL LIGHTING MSAS07-WH Inner Corner Instructions
- June 13, 2024
- KENDAL LIGHTING
Table of Contents
KENDAL LIGHTING MSAS07-WH Inner Corner
ACCESSORIES REQUIRED
DIMENSIONS
INSTALLATION STEPS
- STEP 1 REMOVE THE END CAP FROM TRACK
- STEP 2 REMOVE THE DECORATIVE PLATE. IF CONNECTING TO THE END OF THE TRACK THAT DOES NOT HAVE A DECORATIVE PLATE SKIP TO STEP 5.
- STEP 3 REMOVE MAGNET
- STEP 4 INSERT THE MSA01 POWER PLATE(d) – SOLD SEPARATELY
- STEP 5 INSTALL THE MSA22 PIN SET(b) INTO THE PIN CONNECTOR HOLES (c) ON THE TRACK. SLIDE THE TRACK CONNECTOR (a) HALFWAY AND SURE TO TRACK WITH TO SET SORELY
- STEP 6 SHE IS IN UP THEN SET ONE RACE AND THE PIN SETS HOLES ON THE TRACK CORNER.
- ATTENTION:
- WHEN JOINING TRACKS OR ACCESSORIES UTILIZING PIN
- CONNECTORS, MAKE SURE PINS ARE HORIZONTAL AND LINE
- UP WITH PIN CONNECTOR HOLES. YOU MAY NEED TO GENTLY
- PUSH UP OR DOWN ON THE PINS SO THEY LINE UP CORRECTLY.
- FAILING TO DO THIS MAY RESULT IN PINS MISSING THE PIN
- CONNECTOR HOLES AND LOSS OF THE 24-VOLT CONNECTION.
- STEP 7 SEGNER HEREM MITO SET SEREN (a) TO THE TRACK
- STEP 8 REPEAT STEPS 1 THROUGH 7 FOR THE OTHER SIDE OF THE TRACK CORNER AND COMPLETE THE TRACK CORNER CONNECTION.
NOTE: AFTER EACH TRACK CONNECTION A CONTINUITY TEST SHOULD BE DONE TO ENSURE PROPER ELECTRICAL CONNECTIONS WERE MADE. TRACK CORNER INSTRUCTIONS MSAS07 INNER CORNER
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>