KENDAL LIGHTING MSAS06-WH Degree Magnetic Track Surface Instruction Manual
- June 13, 2024
- KENDAL LIGHTING
Table of Contents
IAGNA
WITHOUT FLANGE TRACK
TRACK CORNER INSTRUCTIONS
MSAS06 45D CORNER
ACCESSORIES REQUIRED
DIMENSIONS
STEP 2 REMOVE DECORATIVE PLATE. IF CONNECTING TO END OF TRACK THAT DOES NOT
HAVE A DECORATIVE PLATE SKIP TO STEP 5.
STEP 3 REMOVE MAGNET
STEP 4 INSERT THE MSA01 POWER PLATE(d) – SOLD
SEPARATELY
STEP 5 INSTALL THE
MSA22 PIN SET(b) INTO THE PIN CONNECTOR HOLES (e) ON THE TRACK. SLIDE THE
TRACK CONNECTOR (a) INTO THE SLOT ON THE BACK OF THE TRACK SO THAT THE HOLE ON
THE CONNECTOR LINES UP WITH THE SECOND HOLE IN FROM THE END OF THE TRACK AND
SECURE WITH 3 SET SCREWS(SEE INSET PICTURE).
STEP 6 SLIDE MSAS06 TRACK CORNER ONTO THE TRACK CONNECTOR (a) WHILE CAREFULLY
LINING UP THE PIN SET WITH THE PIN SET HOLES ON THE MSASOS TRACK
CORNER.
ATTENTION:
WHEN JOINING TRACKS OR ACCESSORIES UTILIZING PIN CONNECTORS. MAKE SURE PINS
ARE HORIZONTAL AND LINE UP WITH PIN CONNECTOR HOLES. YOU MAY NEED TO GENTLY
PUSH UP OR DOWN ON THE PINS SO THEY LINE UP CORRECTLY. FAILING TO DO THIS MAY
RESULT IN PINS MISSING THE PIN CONNECTOR HOLES AND LOSS OF THE 24 VOLT
CONNECTION.
STEP 7 SECURE OTHER END OF TRACK CONNECTOR (a) TO THE TRACK CORNER WITH
REMAINING SET SCREW
STEP 8 REPEAT STEPS I
THROUGH 7 FOR OTHER SIDE OF TRACK CORNER AND COMPLETE TRACK CORNER
CONNECTION.
NOTE: AFTER EACH
TRACK CONNECTION A CONTINUITY TEST SHOULD BE DONE TO ENSURE PROPER ELECTRICAL
CONNECTIONS WERE MADE.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>