Ciro 78181 Passenger Floorboard Mount Covers Instruction Manual
- June 13, 2024
- Ciro
Table of Contents
Passenger Floorboard Mount Covers
Instruction Manual
78181 Passenger Floorboard Mount Covers
WARNING This indication alerts you to the fact that ignoring the contents
described herein can result in potential serious injury or death if not
followed.
CAUTION This indication alerts you to the fact that ignoring the contents
described herein can or will result in material damage and/or personal injury.
ATTENTION This indication alerts you to the fact if you ignore this
detail you will affect the performance or functionality of the product.
All Ciro products are designed for “easy assembly” and/or “plug and play”. We
recommend a competent mechanic install our products, using standard mechanical
procedures to assure a safe and successful installation. Read completely and
understand the instructions prior to starting installation.
NOTE: Ciro products are designed and manufactured under very strict
quality control. Ciro warrants that products sold to the original purchaser
shall be free from any defects in materials and workmanship for a period of 3
(three) years from the date of purchase, and a limited lifetime warranty
against LED failure. Ciro will have no obligation if the customer cannot show
proof of purchase. Warranty will not be granted unless the part is properly
installed, unmodified and maintained. Ciro will not be liable for any
consequential and incidental damages, including labor, or non-Ciro products.
Please visit Ciro3d.com for our complete warranty policy.
Installation Instructions: part numbers 78180, 78181
- Place bike on center stand and allow time for engine to cool.
- Open right saddlebag and remove side cover panel. Fig. 1
- Remove two push darts and set aside for reinstall. Push center pin till it clicks to release. Fig. 2
- Remove 3mm Allen screw at bottom of cover. Fig. 3
- Remove 10mm hex bolt at top left of cover. Fig. 4
- Pull wire cable from clip and remove cover. Right side only. Fig. 5
- Remove grommet, wire cable clip and bumper from old cover and install on new cover. Fig. 6
- Install new right side cover in reverse order.
- Left side installation the same procedure except there is no wire clip on the cover.
https://qrco.de/bdEqzX G0078180, REV._A
For the latest version of installation instructions visit
www.goldstrike3d.com
Goldstrike3D.com
References
- Ciro3D: Motorcycle Accessories & Parts
- The leader in Honda Gold Wing & Motorcycle Parts & Accessories – Goldstrike
- Ciro3D: Motorcycle Accessories & Parts
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>