The Great Outdoors 73320-73321-66A Cameo Shores 1-Light Black Outdoor Wall Mount Instruction Manual

June 13, 2024
THE GREAT OUTDOORS

The Great Outdoors 73320-73321-66A Cameo Shores 1-Light Black Outdoor

Wall Mount

MOUNTING THE FIXTURE (Fig. 1)

  1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

  2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.

  3. Attach mounting plate (A) to junction box (not included) using mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate marked “GND” must face out.
    CONNECTING THE WIRES (Fig. 2)The-Great-Outdoors-73320-73321-66A-Cameo-
Shores-1-Light-Black-Outdoor-Wall-Mount-fig-2

  4. Connect the electrical wires as shown in Figure 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to mounting plate (A) using the green screw provided.

  5. Tuck wire connectors neatly inside the junction box.
    COMPLETING THE INSTALLATION (Fig. 1)

  6. Place fixture body (D) onto a mounting plate (A) followed by a plastic washer (E) and secure with screws (C).

  7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. Indoor/Outdoor Silicone Sealant) to outline the outside of the fixture back plate where it meets the wall leaving a space at the bottom to allow moisture a means to escape (Fig.3).The-Great-Outdoors-73320-73321-66A-Cameo-Shores-1-Light-Black-Outdoor-Wall-Mount-fig-3

  8. Install (1) one candelabra base bulb (G) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!) Place glass shade (H) over a socket (F) and twist until secured on the socket cup. Your installation is now complete. Return power to the
    junction box and test the fixture.
    Note : The illustration (Fig. 1) in this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

THE GREAT OUTDOORS User Manuals

Related Manuals